2
29
d
b
a
c
a
e
f
EN
Recording
About recording
Notes
• To ensure that you do not lose the
beginning of the recording, verify that
the LED indicator light or the mode
indicator is lit on the display.
• When the remaining recording time is
less than 60 seconds, the LED indicator
light starts flashing. When the remaining
recording time drops to 30 and then 10
seconds, the light flashes faster.
1 Select a recording folder
( ☞ P.26).
2 Press the
REC
( s ) button to start
recording.
• The LED indicator light turns on and
[ K ] appears on the display.
• Turn the microphone in the direction
of the source to be recorded.
a Recording mode indicator
b Elapsed recording time
c Remaining memory bar indicator
d Remaining recording time
e Level meter (changes according to
the recording level and recording
function settings)
f File length
Before starting recording, select a folder
among [ & ] to [ * ]. These five folders can be
used to categorize recorded information
according to type; for example, Folder [ & ]
might be used to store private information,
while Folder [ ' ] might be dedicated to
holding business information.
R e c o r d i n g
REC
( s ) button
STOP
( 4 ) button
• [ Rec Mode ] cannot be changed in
recording standby mode or while
recording. Configure this while the
recorder is stopped ( ☞ P.56).
• The proper position of the built-in
stereo microphone for performing
stereo recording is over the display. If
the microphone is below the display
during recording, proper stereo
recording is impossible because the
original sound will be recorded in
reverse phase.
3 Press the
STOP
( 4 ) button to stop
recording.
• [ L ] appears on the display.
To Next Page
Loading...
Need help?
General
