22
2. Remain still and do not move or talk until the entire measurement
process is completed.
As the cuff inflates, your monitor automatically determines your ideal inflation
level. This monitor detects your blood pressure and pulse rate during inflation.
The “ ” symbol flashes at every heartbeat.
• When the “ ” symbol is displayed, the wrist cuff is not applied correctly.
Press the [START/STOP] button to turn your monitor off, then apply the cuff
correctly.
After your monitor has detected your blood pressure and pulse rate, the cuff
automatically deflates. Your blood pressure and pulse rate are displayed.
If either the systolic or the diastolic reading is high (refer to section 1.3), the
“ ” symbol appears.
3. Press the [START/STOP] button to turn your monitor off.
• Your monitor will automatically turn off after 2 minutes.
• Wait 2 - 3 minutes between measurements. The wait time allows the arteries
to decompress and return to their pre-measurement form. You may need to
increase the wait time depending on your individual physiological
characteristics.
To Next Page
Loading...
Need help?
General
