Digital Temperature Controllers E5CN/E5CN-U 1
Digital Temperature Controllers
E5CN/E5CN-U
This Best-selling General-purpose 48×48-mm
Temperature Controller Is Now Even Better.
USB-Serial Conversion Cable and Support
Software Are Also Available.
• Controllers now available with analog inputs.
• Faster sampling at 250 ms.
• Transfer output provided for easy output to recorders.
• Voltage outputs (to drive SSRs) for both heating and cooling
control. Can be used for alarms to provide three alarm outputs.
• Models available with three-phase heater burnout detection and
SSR fault detection.
• Easy setting with 11-segment displays.
• Connect to either a thermocouple or platinum resistance
thermometer with the same model.
• Easily see the status from a distance with PV display with three-
color switching function.
• Setting protection indicator informs operator when protection is
enabled.
• Manual output provided.
• Controller available with long-life relay output.
• Models available with external power supply for ES1B Infrared
Thermosensor.
Note: Refer to Precautions on page 21.
Note: Refer to page 19 for information on changes in comparison to
previous models.
Features
Improved Functions for a Wider Range of Application
Control Analog Values, such as Pressures, Flowrates,
and Levels
The E5CN Series now also includes models that accept analog
inputs, enabling control applications other than for temperature,
including pressure, flowrate, level, humidity, and weight control.
Note: E5CN-@L (Models with Analog Inputs)
Faster Sampling at 250 ms
The previous sampling time of 500 ms has been reduced by half to
250 ms. This enables the E5CN to handle application requiring even
greater response speed and accuracy.
Easy Connector to a Recorder
A transfer output now makes it easy to connect to a recorder or PLC
Analog I/O Unit.
Note: E5CN-C@ (Models with Current Outputs)
Voltage Outputs (to Drive SSRs) for Both Heating and
Cooling Control. Can Be Used for Alarms to Provide
Three Alarm Outputs.
Voltage outputs can be used for both heating and cooling for Models
with Two Control Outputs. Also, control output 2 can be set for use as
an alarm output, to enable using up to three alarm outputs.
Note: E5CN-@Q (Option Board)
Three-phase Heater Burnout Detection
With Models with Three-phase Heater Burnout and SSR Failure
Detection, two current transformers can be connected to detect both
heater burnout and SSR failure at the same time, reducing costs
because a separate heater burnout alarm device is not required.
SSR failure detection can be used even with Models with Single-
phase Heater Burnout Alarms.
Note: E5CN-@HH@ (Option Board)
E58-CIFQ1 USB-Serial Conversion Cable for Computer Connection
A personal computer connection is possible for models without communications.
The CX-Thermo Support Software (sold separately) can be used to set parameters, monitor operation, and
parameter masks. The free ThermoMini Parameter Copy Software can be used to reach E5CN parameters
using communications and copy them to another E5CN to increase onsite productivity.
Specifications: page 5, Dimensions: page 11
Related Product
• EST2-2C-MV1 CX-Thermo Support Software: page 24
• ES1B Infrared Thermosensor: page 26
To Next Page
Need help?
General
