23
Non-Invasive Blood Pressure (NIBP) Measurement
Stopping the Measurement
To stop measurement while measurement is in progress, press [START/STOP] button.
Displaying Last Reading
The previous measurement value (systolic blood pressure, diastolic blood pressure, and pulse rate)
and whether or not an irregular pulse wave was detected can be displayed. In the case of auscultation
measurement, the auscultation icon appears.
Press the [ ] or [ ] button to display the previous data. This function is also available when the
device is switched off.
Note:
When the monitor is left idle for one minute, the backlight will disappear.
Lights while the previous
data are being displayed.
If an irregular pulse wave or
body movement was detected,
the irregular pulse wave icon
appears.
If held down at least 3 seconds when a measurement result is
displayed, the measured data is cleared without being stored.
When the data was measured
in "Auscultation Mode", the
auscultation icon appears.
HBP-1300.book Page 23 Wednesday, March 7, 2012 9:28 AM
To Next Page
Loading...
Need help?
General
