11.
Confirm the safety of the system before turning ON or OFF the supply
to the unit.
12.
Start actual application only after sufficiently checking screen data and
the operation of the program in the PLC.
13.
When using the Programming Console functions, confirm system safety
and then perform the following operations :
•
Changing monitor data
•
Changing operation modes
•
Forced setting or resetting
•
Changing preset values or set values.
14.
Do not press the key switch with a force greater than 30N.
15.
Do not accidently press key switches when the backlight is not lit or when
the display does not appear. Confirm the safety of the system before
pressing key switches.
16.
Do not attempt to disassemble, repair or modify the units in any way.
17.
Do not use benzene, paint thinner or other volatile solvents and do not
use chemically treated cloths.
18.
Signals from the key switches may not be input if the switches are
pressed consecutively at high speed. Confirm each input before
proceeding to the next one.
19.
To ensure greater safety for numeric inputs, first check for proper limits
in the PLC.
NOTES
Page 4
Page 17
Page 2
Page 19
NOTES
To Next Page
Loading...
Need help?
General
