• Some TVs support only 2-channel PCM audio.
• If there’s no sound, try changing the following set-
tings:
1. Change the Digital/HDMI Audio Out setting to
PCM.
2. Change the Linear PCM Out setting to Down
Sample On.
Don’t forget to make the necessary settings on your
AV receiver, including:
• HDMI video input and output settings
• HDMI audio input and output settings
• Input source settings (i.e., is the HDMI IN assigned to
the DVD input source?)
Refer to your AV receiver’s instruction manual for
details.
DV-CP706 HDMI Setup Guide
HDMI carries audio and video via a single cable. An HDMI connection can:
• Carry high-definition video digitally (1080p/1080i/720p up conversion)
• Carry Dolby Digital and DTS surround sound digitally
• Make hookup quick and easy because audio, video, and control signals are carried by a single cable
•Keep the rear of your equipment neat and tidy because there’s less cabling
Connecting to a TV
HDMI
IN
HDTV,
projector
Signal flow
HDMI cable
Audio
Digital/HDMI Audio Out
Dynamic Range Control
Linear PCM Out
√ PCM
All
Off
Audio
Digital/HDMI Audio Out
Dynamic Range Control
Linear PCM Out
√ Down Sample On
Down Sample Off
Connecting to an AV Receiver
AV receiver
HDMI
IN
HDMI
HDMI
IN
HDTV,
projector
Signal flow
HDMI cable
After the DV-CP706 and the other component have
been turned on and an HDMI link established
between them, “HDMI OUT” will appear on the
display. While the link is being established, “HDMI
OUT” will flash on the display. If a link cannot be
established (e.g., the HDMI cable is disconnected or
the other component is not turned on), “HDMI
STDBY” will appear on the display.
En
DV-CP706QuickGuide.fm Page 1 Friday, July 11, 2008 10:34 AM
To Next Page
Need help?
General
