E N G L I S H
4
Assembly
Warranty
ORECK MANUFACTURING COMPANY: (Oreck gives you the
following limited warranty for this product only if it was originally
purchased for use, not resale, from Oreck or an Oreck Authorized
Retail Dealer.)
Oreck will repair or replace, free of charge, to the original
purchaser, any part which is found to be defective in material or
workmanship within one (1) year of the date of purchase. This
limited
warranty covers the revolving roller brush for thirty (30)
days for commercial use only.
This limited warranty does not cover the replacement of
expendable or consumable parts such as carbon motor brushes,
edge brushes, bulbs, disposable bags and other parts subject to
normal wear unless they are defective in material or workmanship.
This limited warranty does not apply to any part subjected to
accident,
abuse, or alteration, misuse, damage caused by fire or
act of God, the use of voltages other than indicated on the serial
number plate of this product or service of this product by other than
Oreck or an Oreck Factory Authorized Service Center.
Oreck does not authorize any person or representative to assume
or grant any other warranty obligation with the sale of this
product.
Oreck’s limited warranty is
valid only if you retain proof of
purchase from Oreck or an Oreck Authorized Retail Dealer for this
product. If you purchase this product from any other source, your
purchase is “AS IS,” which means Oreck grants you no warranty,
and that you, not Oreck, assume the entire risk of the quality and
performance of this product, including the entire cost of any
necessary servicing or repairs of any defects.
O
reck’s liability for damages to you for any costs whatsoever
arising out of this statement of limited warranty shall be limited to
the amount paid for this product at the time of original purchase,
and Oreck shall not be liable for any direct, indirect, consequential
or incidental damages arising out of the use or inability to use this
product.
Some states do not allow the exclusion or limitation of inc
idental
or consequential damages, so the above limitation or exclusion
may not apply to you.
ALL EXPRESS AND IMPLIED WARRANTIES FOR THIS PRODUCT,
INCLUDING IMPLIED WARRANTIES OF MERCHANTABILITY AND
FITNESS FOR A PARTICULAR PURPOSE, ARE LIMITED IN
DURATION TO THE WARRANTY PERIOD, AND NO
WARRANTIES, WHETHER EXPRESS OR IMPLIED, WILL APPLY
AFTER THIS PERIOD.
Some states do not allow limitations on the duration
of implied
warranties, so the above limitation may not apply to you.
This warranty gives you specific legal rights, and you may also
have other rights which vary from state to state.
1
Before assembling appliance, remove two
screws from the connector assembly.
Remove plastic insert by pulling upward.
With ON/OFF switch facing the front
of the unit, slide upper handle section
over matching section of the connector
assembly. Place brace against handle
and connection assembly aligning the
holes. Insert one screw into top hole
and one screw into the bottom hole
then tighten firmly until hand
le is no
longer loose.
2
3
Upper
Handle
Connector
Assembly
Attach cord to cord clip by pressing
cord above and below clip ensuring
the cord is fully rested in clip.
If the vacuum becomes overloaded, which could occur by sucking
up a large obstruction or on extremely thick carpet, the electronics
are designed to shut down the vacuum. If this happens, the vacuum
will be turned off. To reset the vacuum turn the unit off, wait 5
seconds, and then turn it back on. If it shuts down again there may
be a large obstruction in the vacuum. See page 6 for the steps on
clearing
a blockage.
Motor Protection -
Vacuum Shutdown
To assist you in identifying components of your vacuum,
the parts have been numbered as follows
:
1 Handle section, upper
2 Tube, lower
3 Power head
4 Outer bag
5 Paper filter
dust bag
6 Power cord
7 Retaining
spring
8 Bag tension
bar
9 Zip fastener
10 ON/OFF
switch
11 Cord hook
12 Plastic loop/cable clamp
13 Connector Assembly/
Rear Carry Handle
14 Fan housing
15 Cord assembly
16 Cord-L
ock
17 Pigtail
10
1
2
3
4
5
6
7
8
9
11
12
13
14
15
16
17
To Next Page
Loading...
Need help?
General
