EasyManuals Logo
Home>Ouellet>Heat Pump>SED12KCH17S

Ouellet SED12KCH17S User Manual

Ouellet SED12KCH17S
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #12 background imageLoading...
Page #12 background image
When setting T-ON, T-OFF or CLOCK, press "▲" or "r CLOCK, press "▲" or "
(Refer to CLOCK, T-ON, T-OFF buttons).
Note:
Press this button continuously more th n 2s, the main unit will swing back and
forth from left to right, and then loosen the button, the unit will stop swinging and
present position of guide louver will be kept immediately.
Under swing left and right mode, whe the status is switched from of
This function is applicable to partial of
odels.
f to , if
press this button again 2s later, status will switch to off status directly; if press
this button again within 2s, the change of swing status will also depend on the
circulation sequence stated above.
Introduction for buttons on remote controller
7
button
Press this button can select up & down swing angle. Fan blow angle can be selected
circularly as below:
When selecting " ", air conditioner is blowing fan aut matically. Horizontal
louver will automatically swing up & down at maximum angle.
When selecting "
", air conditioner is blowing fan at fixed
position. Horizontal louver will stop at the fixed position.
When selecting
", air conditioner is blowing fan at fixed angle.
Horizontal louver will send air at the fixed angle.
Hold " button above 2s to set your required swing angle. When reaching your
required angle, release the button.
no display
(horizontal louvers stops
at current position)
6
Press this button can select left & right swing angle. Fan blow angle can be selected
circularly as below:
button
no display
(stops at current position)
to exit turbo function and " " icon will disappear.
If start this function, the unit will run at super-high fan speed to cool or heat quickly
so that the ambient temp. approachs the preset temp. as soon as possible.
▲/ button
5
Press "▲" or " button once increase or decrease set temperature 1
(°F).
Holding "▲" or " " button, 2s later, set temperature on remote controller will
change quickly. On releasing button after setting is finished, temperature indica-
tor on indoor unit will change accordingly.
12

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ouellet SED12KCH17S and is the answer not in the manual?

Ouellet SED12KCH17S Specifications

General IconGeneral
BrandOuellet
ModelSED12KCH17S
CategoryHeat Pump
LanguageEnglish

Related product manuals