UIET
1
3
2
Basic operation
1
Select the desired mode
AUTO HEAT COOL
FANi AUTO-X DRY
2
Start/stop the operation
POWER
• Please note that the OFF
indication is on to start.
3
Select the desired
temperature
• Selection range: 16 °C ~
30 °C (Not applicable for
FAN mode).
•
Operating the unit within the
recommended temperature
may save energy.
HEAT : 20 °C ~ 24 °C.
COOL: 26 °C ~ 28 °C.
DRY : 1 °C ~ 2 °C lower than
room temperature.
• To dim or restore the unit’s
indicator brightness, press
and hold for 5 seconds.
• Use remote control within 8 m
from the remote control receiver
of the indoor unit.
The illustrations in this manual are for explanation purposes
only and may differ from the actual unit. They are subject to
change without notice for future improvement.
Table of contents
Safety precautions ...................4-5
How to use...............................6-7
To learn more... ......................8-9
Cleaning instructions ................ 10
Troubleshooting ........................ 11
Information.................Back cover
Accessories
• Remote control
• AAA or R03 batteries × 2
• Remote control holder
• Screws for remote control
holder × 2
WARNING
This symbol shows
that this equipment
uses a fl ammable
refrigerant. If the
refrigerant is
leaked, together
with an external
ignition source,
there is a
possibility of
ignition.
CAUTION
This symbol shows
type of fl ammable
refrigerant
contained in the
system.
CAUTION
This symbol shows
that the Operation
Instructions should
be read carefully.
CAUTION
This symbol shows
that a service
personnel should
be handling this
equipment with
reference to the
Installation
Instructions.
CAUTION
This symbol
shows that there
is information
included in
the Operation
Instructions and/
or Installation
Instructions.
F570018-SA0815-1.indb 3F570018-SA0815-1.indb 3 17/08/2015 2:42:42 PM17/08/2015 2:42:42 PM
Process BlackProcess Black