Above is the image if a Panasonic KX-TGP500,
these Do NOT have an attached Corded Base
Handset. Note the KX-TGP500 will be missing
the option to configure a Base Handset.
Above is the image if a Panasonic KX-TGP550,
these DO have a Base Corded Handset
attached, and will allow for the Base
Handset to have a separate Line configured
to it.
Panasonic KX-TGP500 and KX-TGP550:
(Even though the Base supports up to 6 Handsets, these are ONLY able to support 3 Simultaneous calls)
How to Configure Panasonic KX-TGP500 and KX-TGP550:
Connect you Panasonic KX-TGP5XX to the power and network using the LAN port on the Base. You will then need to
locate the “ALL” button on the Base. Once Located you will want to register your Handsets to the base following the
below instructions:
1.
Press the “ALL” button on Base and hold for 4 Seconds
2.
After hear the beep you will press the “OK” softkey on handset (Some firmware or models may require a PIN this
will be 0000)
3.
After the handset completes its registration to the base it will beep
4.
The Base status light should turn Green and the handset should show the Date/Time (May not be
correct)
To De-Register Handsets use the following steps:
1.
Press Menu
2.
Select Initial Settings
3.
Select Registration
4.
Select Deregistration and enter the 3 digit code that appears on the screen, then Press OK
5.
Now you will be able to Select the Handset to Deregister
6.
When prompted to Erase, Select Yes
7.
If successfully deregistered you will see, “Press ALL on base 4sec. Then press OK”
8.
Repeat these steps as needed for each handset.
To Next Page
Need help?
General