Operating Instructions
Compact Stereo System
Model No. SC-HC25
Dear Customer
Thank you for purchasing this system.
For optimum performance and safety, read
these instructions fully before you connect,
operate or adjust this system.
Keep this manual for future reference.
Your system and the illustrations can look
differently.
Do the procedures with the remote
control. You can also use the buttons
on the main unit if they are the same.
En
RQTX1256-B
L0111CH0
SUPPLIED ACCESSORIES
Please check and identify the supplied accessories.
1 x AC mains lead
1 x FM indoor antenna
1 x AM loop antenna
1 x Remote control
(N2QAYB000640)
1 x Remote control
battery
CAUTION!
THIS PRODUCT UTILIZES A LASER.
USE OF CONTROLS OR ADJUSTMENTS
OR PERFORMANCE OF PROCEDURES
OTHER THAN THOSE SPECIFIED HEREIN
MAY RESULT IN HAZARDOUS RADIATION
EXPOSURE.
DO NOT OPEN COVERS AND DO NOT REPAIR
YOURSELF. REFER SERVICING TO QUALIFIED
PERSONNEL.
THIS UNIT IS INTENDED FOR USE IN
MODERATE CLIMATES.
The socket outlet shall be installed near the
equipment and easily accessible.
The mains plug of the power supply cord shall
remain readily operable.
To completely disconnect this apparatus from the
AC Mains, disconnect the power supply cord plug
from AC receptacle.
This product may receive radio interference
caused by mobile telephones during use. If
such interference is apparent, please increase
separation between the product and the mobile
telephone.
Product identification marking is located on the
bottom of unit.
Placement
Set the system up on an even surface away from
direct sunlight, high temperatures, high humidity,
and excessive vibration. These conditions can
damage the cabinet and other components, thereby
shortening the service life of the system.
Place it at least 15 cm away from wall surfaces to
avoid distortion and unwanted acoustical effects.
Do not place heavy items on the system.
Voltage
Do not use high voltage power sources. This can
overload the system and cause a fire.
Do not use a DC power source. Check the source
carefully when setting the system up on a ship or
other place where DC is used.
AC mains lead protection
Ensure the AC mains lead is connected correctly
and not damaged. Poor connection and lead
damage can cause fire or electric shock. Do not
pull, bend, or place heavy items on the lead.
Grasp the plug firmly when unplugging the lead.
Pulling the AC mains lead can cause electric shock.
Do not handle the plug with wet hands. This can
cause electric shock.
SAFETY PRECAUTIONS
WARNING:
TO REDUCE THE RISK OF FIRE, ELECTRIC
SHOCK OR PRODUCT DAMAGE,
• DO NOT EXPOSE THIS APPARATUS
TO RAIN, MOISTURE, DRIPPING OR
SPLASHING AND THAT NO OBJECTS
FILLED WITH LIQUIDS, SUCH AS VASES,
SHALL BE PLACED ON THE APPARATUS.
• USE ONLY THE RECOMMENDED
ACCESSORIES.
• DO NOT REMOVE THE COVER (OR BACK);
THERE ARE NO USER SERVICEABLE
PARTS INSIDE. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.
CAUTION!
• DO NOT INSTALL OR PLACE THIS UNIT IN
A BOOKCASE, BUILT-IN CABINET OR IN
ANOTHER CONFINED SPACE. ENSURE
THE UNIT IS WELL VENTILATED. TO
PREVENT RISK OF ELECTRIC SHOCK OR
FIRE HAZARD DUE TO OVERHEATING,
ENSURE THAT CURTAINS AND ANY OTHER
MATERIALS DO NOT OBSTRUCT THE
VENTILATION VENTS.
• DO NOT OBSTRUCT THE UNIT’S
VENTILATION OPENINGS WITH
NEWSPAPERS, TABLECLOTHS, CURTAINS,
AND SIMILAR ITEMS.
• DO NOT PLACE SOURCES OF NAKED
FLAMES, SUCH AS LIGHTED CANDLES, ON
THE UNIT.
• DISPOSE OF BATTERIES IN AN
ENVIRONMENTALLY FRIENDLY MANNER.
Inside of product
Foreign matter
Do not let metal objects fall inside the system. This
can cause electric shock or malfunction.
Do not let liquids get into the system. This can
cause electric shock or malfunction. If this occurs,
immediately disconnect the system from the power
supply and contact your dealer.
Do not spray insecticides onto or into the system.
They contain flammable gases which can ignite if
sprayed into the system.
Service
Do not attempt to repair this system by yourself.
If sound is interrupted, indicators fail to light,
smoke appears, or any other problem that is not
covered in these instructions occurs, disconnect
the AC mains lead and contact your dealer or an
authorised service centre. Electric shock or damage
to the system can occur if the system is repaired,
disassembled or reconstructed by unqualified
persons.
Extend operating life by disconnecting the system
from the power source if it is not to be used for a
long time.
3
OVERVIEW OF CONTROLS
RADIO
EXT-IN
SOUND
PRESET EQ
D.BASS
DISPLAY
DIMMER
SLEEP
PLAY
AUTO OFF
A
B
C
D
E
G
F
H
J
I
K
L
N
M
O
P
Refer to the numbers in parentheses for
chapter references.
A Standby/on switch [
`
], [
1
] (7, 11)
Press to switch the unit from on to standby
mode or vice versa. In standby mode, the
unit is still consuming a small amount of
power.
B Numeric buttons [1 to 9, 0, ≧10]
To select a 2-digit number
Example: 16: [≧10] → [1] → [6]
C Delete a programmed track (4)
D Select source
[iPod]: Select iPod (5)
[CD]: Select disc (4)
[RADIO, EXT-IN]: Select radio, USB or
AUX (6, 9)
E Basic operation
[
4
/
9
]: Playback or pause operation
[
8
]: Stop playback
[
2
], [
6
]: Skip track
Select preset radio station
[
3
], [
5
]: Search track
Tune in to the radio station
[
2
/
3
], [
5
/
6
]: Skip and search
track
Select preset
radio station
F Select the sound effects (8)
G Select the iPod menu item (5)
H View the information shown on the display
panel.
Decrease the brightness of the display
panel
Press and hold the button to use this
function.
To cancel, press and hold the button again.
I Set the sleep timer (7)
Set the clock and timer (7)
J Set the program function (4, 6)
K Adjust the volume of the system
L Mute the sound of the system
Press the button again to cancel.
“MUTE” is also cancelled when you adjust
the volume or when you switch off the
system.
M Set the play menu item (4)
N Set the radio menu item (6)
O [
R
,
T
]: Skip album
Adjust clock setting
[
Y
,
U
]: Select the item in the menu
[OK]: Confirm the setting
P Automatically switch off the system
This function switches off the system
(except in radio source) if you do not use
the system for approximately 30 minutes.
To cancel, press the button two times.
Q Headphones jack (
)
Plug type: Ø 3.5 mm stereo (not included)
• Avoid listening for prolonged periods of
time to prevent hearing damage.
• Excessive sound pressure from
earphones and headphones can cause
hearing loss.
• Listening at full volume for long periods
may damage the user’s ears. Be sure
to use the supplied or recommended
headphones or earphones.
R AUX jack
S USB port ( )
T Open or close the sliding door
U Display panel
V Sliding door
W Remote control sensor
X Open or close the iPod or iPhone dock
Bottom of product
SPECIFICATIONS
1
MAKING THE CONNECTIONS
2
PREPARING THE REMOTE CONTROL
MAINTENANCE
Amplifier section
RMS output power stereo mode
Front Ch (both ch driven)
5 W per channel (6
), 1 kHz, 10% THD
Total RMS stereo mode power 10 W
FM/AM tuner, terminals section
Preset station FM 30 stations
AM 15 stations
Frequency modulation (FM)
Frequency range
87.50 MHz to 108.00 MHz (50 kHz step)
Antenna terminals 75
(unbalanced)
Amplitude modulation (AM)
Frequency range
522 kHz to 1629 kHz (9 kHz step)
520 kHz to 1630 kHz (10 kHz step)
Headphones jack
Terminal Stereo, 3.5 mm jack
AUX (rear)
Terminal Stereo, 3.5 mm jack
Disc section
Disc played (8 cm or 12 cm)
CD, CD-R/RW (CD-DA, MP3
formatted disc)
MPEG-1 Layer 3, MPEG-2 Layer 3
Pick up
Wavelength 790 nm (CD)
Laser power CLASS 1 (CD)
Audio output (Disc)
Number of channels 2 ch (FL, FR)
FL = Front left channel
FR = Front right channel
Conserving power
The system consumes approximately 0.2 W when it
is in standby mode. Disconnect the power supply if
you do not use the system.
Some settings will be lost after you disconnect the
system. You have to set them again.
1
Connect the FM indoor antenna.
Place the antenna where reception is best.
Adhesive tape
Use alkaline or manganese battery.
Install the battery so that the poles (+ and –) align
with those in the remote control.
Point the remote control at the remote control
sensor, away from obstacles, at a maximum range
of 7 m directly in front of the main unit.
To clean this system, wipe with a soft, dry cloth.
• Never use alcohol, paint thinner or benzine to clean this system.
• Before using chemically treated cloth, read the instructions that came with the cloth carefully.
USB section
USB port
USB Standard USB 2.0 full speed
Media file format support MP3 (
.mp3)
USB device file system FAT 12, FAT 16, FAT 32
USB port power 500 mA (max)
Speaker section
Type 1 way, 1 speaker system (bass reflex)
Speaker unit(s)
Full range 8 cm cone type
Impedance 6
Frequency range 60 Hz to 25 kHz (–16 dB)
90 Hz to 22 kHz (–10 dB)
General
Power supply AC 220 to 240 V, 50 Hz
Power consumption 19 W
Dimensions (W x H x D)
400 mm x 221 mm x 110 mm
[D = 69 mm (min)]
[D = 149 mm (tray open)]
Mass 2.1 kg
Operating temperature range 0°C to +40°C
Operating humidity range
35% to 80% RH (no condensation)
Power consumption in standby mode
0.2 W (approximate)
Note:
1) Specifications are subject to change without notice.
Mass and dimensions are approximate.
2) Total harmonic distortion is measured by the digital
spectrum analyzer.
2
Connect the AM loop antenna.
3
Connect the AC mains lead.
Use the included AC mains lead with this system
only.
Do not use an AC mains lead from other
equipment.
Note:
• These speakers do not have magnetic shielding. Do
not put them near TVs, PCs or other equipment easily
influenced by magnetism.
• You cannot remove the net of the speakers.
Click!
CAUTION!
• Do not break open or short-circuit the battery.
• Do not charge the alkaline or manganese battery.
• Do not use the battery if the cover has peeled off.
• Do not heat or expose to flame.
• Do not leave the battery(ies) in an automobile
exposed to direct sunlight for a long period of time
with doors and windows closed.
• Mishandling of battery can cause electrolyte leakage,
which can cause a fire.
• Remove the battery if you do not use the remote
control for a long period of time. Keep in a cool, dark
area.
CAUTION!
Danger of explosion if battery is incorrectly
replaced. Replace only with the same
or equivalent type recommended by the
manufacturer. Dispose of used batteries
according to the manufacturer’s instructions.
“Made for iPod” and “Made for iPhone” mean that an electronic accessory has been designed to connect
specifically to iPod, or iPhone, respectively, and has been certified by the developer to meet Apple
performance standards.
Apple is not responsible for the operation of this device or its compliance with safety and regulatory
standards.
Please note that the use of this accessory with iPod, or iPhone may affect wireless performance.
iPhone, iPod, iPod classic, iPod nano, and iPod touch are trademarks of Apple Inc., registered in the U.S.
and other countries.
MPEG Layer-3 audio coding technology licensed from Fraunhofer IIS and Thomson.
Top view
Front view
Panasonic Corporation
Web Site: http://panasonic.net
– If you see this symbol –
Information on Disposal in other Countries outside the European Union
This symbol is only valid in the European Union.
If you wish to discard this product, please contact your local authorities or dealer and ask for
the correct method of disposal.
GN
SC-HC25_GN_en.indd 1SC-HC25_GN_en.indd 1 2/9/2011 4:26:27 PM2/9/2011 4:26:27 PM
To Next Page
Need help?
General
Weight and Dimensions
