Paradox Security System Graphic Dept - PRINTED IN CANADA
The LED must be " ",
indicating all zones are closed,
before the system can be armed.
When flashing, it indicates
that the exit delay is in progress.
green on
READY
The red LED illuminates
when the system is armed.
ARMED
"FAST ARM" key
( / mode)
Press this key for 2
seconds and the system
arms automatically.
There's no need to
enter an access
code.
regular stay
10
Activates "STAY" arming.
If you want to stay on the premises,
but still be protected, "stay" (partial system)
arming permits movement in pre-selected,
unarmed zones.
STAY
11
Made a mistake entering
info on the keypad? Just
press the key - it
erases any keypad entries
and returns the control panel
to its previous status.
[CLEAR]
CLEAR
Activates
programmable
output #1
(Let your installer
deal with it!!!)
Programmable "chime" zones.
Pressing for 3 sec any of these
keys will activate chime zones
(intermittent beeps) or
de-activate chime zones
(continuous beeps).
*
(SOFTWARE 3.1 AND OVER)
2ND
Indicates AC
power failure.
TRBL
When "on", this
key indicates that if
alarms were generated
while the system was
armed. Pressing on
will bring up alarm "events"
stored in memory.
[MEM]
MEM
Use this key to store
keypad entries in memory.
ENTER
+CODE
Activates manual
zone bypassing.
You select which
zones to leave
open when arming
the system.
BYP
+CODE
"AWAY" auto bypass arming.
Need to leave in a hurry?
This key automatically
bypasses any open zones
before arming the system.
Press this key for 3 seconds to
enable keypad buzzer total
"muting" (intermittent beep) or
disable it (continuous beep).
AWAY
12
9
+CODE
1
2
3
4
5
6
97 8
10
STAY
11
AWAY
12
ENTER
CLEAR
2ND
TRBL
MEM
BYP
UM727 970213-0001
User Manual
S E C U R I T Y
SYSTEMS
PR DOX
VERSION 3.3
ESPRIT
727
U
LISTED
To Next Page
Need help?
General
