EasyManuals Logo
Home>Paradox>Control Panel>Esprit 738 Express+

Paradox Esprit 738 Express+ User Manual

Paradox Esprit 738 Express+
13 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
SOFTWARE VERSION 3.10
HEXA PROGRAMMING:
Addresses 000 to 043 and 300 to 527 are programmed using the Hexa Programming method. In this mode, you can enter
any hexa-digit from 0-F where keys [1] to [9] represent digits 1 to 9 respectively; the other keys represent hexa digits A to
F as shown in figure 1. To program using the Hexa Programming method:
1) Press [
ENTER] + Installer Code (default: 737373)
2) The [ENTER] key will flash indicating you are in programming mode
3) Enter the desired 3-digit address
4) The keypad will display the 2-digit data currently saved at this address as described in figure 2
5) Enter 2-digit data; after entering data you do not need to press [
ENTER], the software will automatically save the data
into the selected address
6) Return to step 2 or press [
CLEAR] to exit programming mode
STREAMLINED SECTION PROGRAMMING
This is an alternate method to Hexa Programming. The addresses (000-043 and 300-527) programmed in the Hexa
Programming method are grouped into 67 sections where each section contains four addresses (i.e. section 00 =
addresses 000-003). Using this method allows you to program 8 digits (4 addresses) without having to exit and re-enter
addresses. Note, the keypad will not display the current data in the Hexa Streamlined Programming method. To program
using the Hexa Streamlined Section method:
1) Press [
ENTER]+ Installer code (default: 737373) + [7]
2) The [ENTER] and [2ND] keys will flash to indicate you are in programming mode
3) Enter 2-digit section (00-67)
4) The [ENTER] key will remain on while the [2ND] key will be off
5) Enter 8-digit data to program the section
6) The keypad will "beep" to indicate that the section has been programmed, data is saved and the software has
advanced to the next section
7) Return to step 4 or press [
CLEAR] to exit programming mode
INSTALLER CODE (Default
737373)
Full access to programming, except user access codes. No access to arming/disarming. Use only numeric keys from [1]
to [10]. (key [10] = 0)
1
38EPEP-05

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Paradox Esprit 738 Express+ and is the answer not in the manual?

Paradox Esprit 738 Express+ Specifications

General IconGeneral
BrandParadox
ModelEsprit 738 Express+
CategoryControl Panel
LanguageEnglish

Related product manuals