When is lit, press it to view the
Trouble Display(button flashes). Each
button that is lit represents a trouble
condition as shown in the keypad door.
When the [8] button is on, press [8] to re-program
the time HH:MM. When the [9] button is on, press
If enabled by your installer , press
and hold buttons:
& for Panic Alarm
& for Medical Alarm
& for Fire Alarm
TROUBLE DISPLAY
When the button is lit, an alarm has
occured. Press the button (button
flashes) andlit numerical buttons will
correspond to zones that were in alarm.
ALARM MEMORY
PRINTED IN CANADA 03/99 - 1686EQ-00
When the button is lit, zones in the
system are currently bypassed
Method 1:
1) Press
2) Enter your [ACCESSCODE]*
3) Illuminate the buttons corresponding to
the zones you wish to bypass or press
1 to recall previous bypass entries
4)Press
Method 2:
1) Press and hold the button for 3
seconds*
2) Go to step 3 in Method 1
*see note1 on reverse side
BYPASS PROGRAMMING
ACCESS CODES
PANIC ALARMS
Press and hold the numerical button
corresponding to the desired zone to
enable or disable chiming for that zone.
CHIME PROGRAMMING
How Do I Program Access Codes?
1) Press
2) Enter your [MASTERCODE]
3) Enter 3-digit [SECTION](see below)
4) Enter the 4 or 6-digit [ACCESSCODE]
Return to step 3 or press
How Do I Delete Access Codes?
1) Repeat steps 1 to 3 (see above)
2) Instead of entering your access
code, press the button once for
each digit in the access code (4 or 6
times) until the keypad emits a
"confirmation beep"
Section [001] = System Master Code
Section [002] = Master Code 1
Section [003] = Master Code 2
Section [004]-[048] = Users 004-048 respectively
Spectra
1686H
LED
Keypad
[9] to view which zones were tampered.
To Previous Page
Need help?
General
