PAX A80 POS User Manual

PAX TECHNOLOGY INC. PAX TECHNOLOGY INC.
A80 Countertop Payment Terminal
AC Power Adapter
Please check the components after unpacking. If any are missing,
or if there is a page missing from the product manual, etc., please
contact the dealer.
Part
The following sections cover basic operating instructions.
Instructions
Figure 1. Front view
1) Printer Cover
2) Contactless Area & Printer Latch
3) Main Screen
4) MSR Reader
5) Power ON/OFF
6) EMV/Chip Reader
7) Cable Guides
8) USB Host (Port)
9) Power (Port)
Figure 2. Back view
10) PIN Pad (Port)
11) RS232 (Port)
12) Serial Number
13) Nameplate
14) SD Card Slot
15) SAM Slots
16) Line (Port)
17) Phone (Port)
18) LAN (Port)
19) USB OTG (Port)
3.1 Power ON/OFF
POWER ON:
Press and hold the power button down for 3-5 seconds and then release.
POWER OFF:
Press and hold the power button down for 3 to 5 seconds and then release.
3.2 SAM/SD Card Installation
Figure 3.SAM and SD Card Slots
The A80 has two SAM card slots on the main body of the device and one
SD card slot. These card slots are normally hidden under the back cover.
In order to install a SD or SAM card into any of these slots, insert a card
into the card slot with the contacts facing upwards and the clipped corner
of the card facing forward and to the right.
Card Readers
4
Magnetic Stripe Card: Slide the card through the card reader slot from
top to bottom or from bottom to top with the magnetic strip oriented
towards the body of the device. Make sure that the card is fully inserted
into the card reader while swiping the card.
Smart Card Reader: Insert the card fully into the reader with the metallic
contacts facing up and towards the device. Make sure that the card is
fully inserted into the card reader while scanning the card.
Contactless Card Reader: The contactless card reader reads cards and
devices placed roughly within an inch (2.5 mm). For best results, place
as close to the reader as possible and center the card over the indicated
area.
Environment
5
Working Environment Temperature: -10°C ~ 50°C (14°F ~ 122°F)
Humidity: 10% ~ 93% (without condensation)
Storage Environment Temperature: -20°C ~ 70°C (-4°F ~ 158°F)
Humidity: 10% ~ 93% (without condensation)
Cleaning the Device
6
Do not use industrial strength or abrasive cleaner as it may damage or
scratch the screen.
Do not immerse the device in water or liquid.
Do not spray water or cleaner into EMV Card Reader or ports.
To clean the screen, apply distilled water or mild glass cleaner onto a soft,
lint-free cloth and gently wipe terminal.
Telephone Cable
Thermal Paper Roll
Quick Setup Guide
AC Power Cable
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19

PAX A80 POS Specifications

General

Brand	PAX
Model	A80 POS
Category	Payment Terminal
Language	English