SP
™
7X
SPECIFICATIONS
Frequency response, 1 meter on-
axis, swept-sine in anechoic
environment:
50 Hz to 19 kHz (±3 dB)
Usable low frequency limit
(-10 dB point):
39 Hz
Power handling:
Full Range:
1,000 W continuous
2,000 W program
4,000 W peak
Low Frequency Section:
1,000 W continuous
2,000 W program
4,000 W peak
High Frequency Section:
80 W continuous
160 W program
320 W peak
Sound pressure level, 1 Watt,
1 meter in anechoic environment:
Full Range:
99.0 dB SPL, (2.00 V input)
Low Frequency Section:
100.0 dB SPL, (2.00 V input)
High Frequency Section:
110.0 dB SPL, (2.83 V input)
Maximum sound pressure level
(1 meter):
Full Range:
129.0 dB SPL continuous
135.0 dB SPL peak
Low Frequency Section:
130.0 dB SPL continuous
136.0 dB SPL peak
High Frequency Section:
129.0 dB SPL continuous
135.0 dB SPL peak
Radiation angle measured at -6 dB
point of polar response:
80 degrees horizontal by
40 degrees vertical
Transducer complement:
Low Frequency Section:
2x 15 in. woofer, vented
1508-8 HE BWX
High Frequency Section:
1x 1.6 in. exit/100 mm voice coil
compression driver on CD Horn
44XT (w/o adapter) on a CH
®
7
Box tuning frequency:
Low Frequency Section:
50 Hz
Crossover frequency (internal
passive):
Low Frequency - High Frequency:
1,400 Hz
Recommended active crossover
frequency region and slope:
Low Frequency - High Frequency:
1,600 Hz at 12 dB/octave
Time offset:
Low Frequency: delay 0.69 ms
High Frequency: 0.00 ms
Impedance (Z):
Full Range:
Nominal: 4.0 Ω
Minimum: 3.9 Ω
Low Frequency:
Nominal: 4.0 Ω
Minimum: 3.6 Ω
High Frequency:
Nominal: 8.0 Ω
Minimum: 7.1 Ω
Input connections:
2x 1/4 in. phone jack and 1x Neutrik
®
NL4 Speakon
®
(bi-amp only)
Enclosure materials and finish:
3/4" OSB finished in black carpet
Mounting provisions:
This unit is not designed for overhead
suspension.
SPECS
PEAVEY ELECTRONICS
To Next Page
Need help?
General
