2
SPECIFICATIONS
Model PY- A4E76R
RMS Power @ 13.8VDC
Power @ 4 Ohms 120W x 4
Power @ 2 Ohms 180W x 4
Bridged Power @ 4 Ohm 300W x 2
Min. Speaker Impedance 2 Ohm
THD Distortion 0.08%
IMD Distortion 0.08%
Frequency Response 20Hz~20KHz
Input Sensitivity 0.2V~6V
Input Impedance 15K
Signal-to-Noise Ratio 90 dB
Channel Separation 50 dB
Remote Bass Control 0.2V~+6V
Crossover Network
Low Pass Filter 50Hz~500Hz
Bass Boost 0dB~+18dB
High Pass Filter 50Hz~1KHz
Fuse Rating 40Ax3
Size L x W x H 495 x 250 x 56mm
+12V
Anode of power connection terminals. Connect to the anode of car battery.
REM
Terminal to be connect with Remote cable, which comes from the source and which
controls the amplifier switching on. Applied voltage must be between 7 and 15VDC.
GND
Ground terminal. Connect to the car underpan . Keep the length of the ground cable
to a minimum.
ELECTRICAL CONNECTION
Connect to chassis
ground of vehicle*
Connect to +12Vof battery with
appropriate FUSE value.
Connect to remote
turn-on lead of
source unit.
CD PLAYER
SEL
G N D G N D
R E M R E M
+ 1 2 V + 1 2 V
To Next Page
Loading...
General