INTELLIFLO
®
AND INTELLIPRO
®
VARIABLE SPEED PUMP DRIVE
ASSEMBLY REPLACEMENT KIT
INSTALLATION GUIDE
Kit Contents
1. Keypad Assembly — (P/N 357527Z [Almond]
or P/N 358527Z [Black]), (Qty. 1)
2. IntelliFlo or IntelliPro Pump Drive Assembly
— (Qty. 1)
3. Screw 10-24 X 3¼ inch PH MS 18-8 S/S
— (P/N 356871), (Qty. 3)
4. Motor Post Cap — (P/N 350142), (Qty. 3)
5. Drive Gasket — (P/N 350108), (Qty. 1)
3
4
5
DO NOT open the strainer pot if pump fails to prime or if pump has been operating
without water in the strainer pot. Pumps operated in these circumstances may
experience a build up of vapor pressure and may contain scalding hot water. Opening the pump may
cause serious personal injury. In order to avoid the possibility of personal injury, make sure the suction and
discharge valves are open and strainer pot temperature is cool to touch, then open with extreme caution.
RISK OF ELECTRICAL SHOCK OR ELECTROCUTION:
PUMPS REQUIRE HIGH VOLTAGE WHICH CAN SHOCK, BURN, OR CAUSE
DEATH. BEFORE WORKING ON PUMP! Always disconnect power to the
pool pump at the circuit breaker from the pump before servicing the pump.
Failure to do so could result in death or serious injury to service person,
pool users or others due to electric shock.
Read all servicing instructions before working on the pump.
IMPORTANT NOTE FOR INTELLIFLO AND INTELLIPRO VS+SVRS DRIVE KITS:
The replacement IntelliFlo or IntelliPro VS+SVRS drive assembly must ONLY be used on
the original IntelliFlo or IntelliPro VS+SVRS pump. This replacement SVRS drive assembly
is NOT to be used with a non-SVRS pump. The original SVRS pump serial number is
referenced in the PO# of this shipment or is included in the body of the packing list. If the
referenced serial number does not match the serial number of the pump being serviced,
please call Pentair Technical Support at 1-800-831-7133.
To Next Page
Need help?
General
