www.philips.com/support
Always there to help you
Register your product and get support at
Question?
Contact
Philips
This product has been manufactured by, and is sold under the responsibility
of Gibson Innovations Ltd., and Gibson Innovations Ltd. is the warrantor in
relation to this product.
Philips and the Philips Shield Emblem are registered trademarks of
Koninklijke Philips N.V. and are used under license.
AZ127_05_QSG_V7.0
Quick start guide
AZ127
Search within play.
Press to open the tape door.
Pause.
Start to play.
1 In CD mode, press to stop playback.
2 Press PROG to activate programming.
3 Press repeatedly to select a track, then press PROG to confirm.
4 Repeat steps 3 to program more tracks.
5 Press to play the programmed tracks.
6 To cancel the program, press twice.
PROG
SHUFFLE
REPEAT
PROG
SHUFFLE
REPEAT
Skip to the previous/next track or search within play.
Stop play or erase a program.
Program the play sequence of tracks.
Play a track or all tracks repeatedly.
Turn on/off the unit.
Play tracks randomly.
Pause or start play.
Program tracks
Quick start guide
www.philips.com/support
Always there to help you
Register your product and get support at
Question?
Contact
Philips
Before using your product, read all accompanying safety information.
6X1.5V R14/UM2/C CELL
To play with the device, you can use either alkaline battery (R14) or AC power.
Make sure that all the buttons are ejected when you close the tape
door with a tape inside.
AC~MAINS
* In CD/FM/AUDIO IN mode, press to power on the device.
* There is no message shown on the display panel in FM or TAPE mode.
* In CD mode, the device switches to standby mode automatically if there is no
playback for over 15 minutes.
AUDIO IN /
AUDIO IN /
ON OFF
AZ127_05_QSG_V7.0.indd 1 2017/6/7 11:06:55