Sonic toothbrush
HX6100, HX6150, HX6902,
HX6910, HX6911, HX6912,
HX6930, HX6932, HX6933,
HX6942, HX6952, HX6982
Published by Philips Consumer Lifestyle Printed in the Netherlands © Copyright Reserved Subject to modification
11/08
PRODUCT INFORMATION
Sanitizing
With the UV sanitizer you can clean your brush head after every
use. After brushing, rinse the brush head and shake off excess
water. To open the sanitizer door, press the door release button.
Place the brush head on one of the two pegs in the sanitizer so
that the bristles are directly facing the light bulb. Close the door
and press the green power on/off button once to start the UV
clean cycle. It runs for 10 minutes then automatically shuts off.
The sanitizer is in operation when the blue light glows through
the Philips logo and the UV clean LED flashes slowly.
Note: The sanitizer stops if the door is opened during operation.
Easy-start
The brushing power will gently increase to full power over the
first 14 brushings.
The Easy-start feature is active if you hear 2 beeps immediately
after turning on your toothbrush.
Once you reach the optimal brushing power, after the 14
th
brushing, you will no longer hear the double beep at the
beginning of the brushing routine.
Easy-start can also be switched off. To deactivate and to
reactivate the Easy-start feature, see directions for use.
Smartimer
Automatically sets the brushing time to 2 minutes.
After these 2 minutes the product switches off automatically.
If you wish to pause, or stop brushing during the 2- minute
cycle, press the on/off button. When you press the on/off button
again, the Smartimer will pick up where you left off.
Programmable brushing modes
The programmable brushing allow you to customize the
brushing action. There are three different brushing modes.
Clean mode is the standard mode for superior teeth cleaning.
Sensitive mode
provides gentle, yet thorough cleaning for
sensitive gums and teeth.
Massage mode provides gentle gum stimulation. .
Programmable brushing routines
The programmable brushing modes and routines allow you to
customize the length of brushing time. Choose 1, 2(factory
default) or 3 minute time intervals.
The 1-minute Go Care
brushing routine has Quadpacer beeps
every 15 seconds.
The 2-minute Clean brushing routine has Quadpacer beeps
every 30 seconds.
The 3-minute Max Care
brushing routine has Quadpacer beeps
every 45 seconds.
Note: The Quadpacer feature cannot be deactivated on the Go
Care and Max Care brushing routines.
Quadpacer
The Quadpacer feature ensures that you brush all four sections
of your mouth evenly and thoroughly. You will hear a short
beep and notice a brief pause in brushing action. This is the
signal to move to the next section of your mouth. To deactivate
and to reactivate the Quadpacer feature, see directions for use.
Philips Domestic Appliance and Personal Care
Service Manual
To Next Page
Need help?
General
