My Philips Sonicare AirFloss is less powerful
If you find that your Philips Sonicare AirFloss is becoming less powerful than before, below you
will find the cause and solution on how you can fix this.
The AirFloss nozzle and reservoir vent is clogged or dirty
If the AirFloss becomes clogged, it is important to clean the inside and outside of the nozzle, as
well as the reservoir vent.
To clean the nozzle, follow the steps below:
1. Remove the AirFloss nozzle from the handle
2. Rinse the nozzle with warm water. We advise you to clean it after each use to eliminate
the residue
To clean the reservoir vent, follow the steps below:
There is a small vent in the reservoir door opening (where you put the water/mouthwash) to let
air in as water is drawn out. If the vent is clogged or dirty, it will reduce and eventually stop the
water flow from coming out of the nozzle.
1. Take a damp/moist paper towel or cotton swab
2. Wipe along the inside edge of the reservoir door opening, especially on the top area
3. Rinse well with cold tap water and ensure that there is no debris/dust left
Note: Ensure that there is no debris from paper towels or cotton swabs inside the reservoir area.
Still have questions? Please contact our Consumer Care Agents for further assistance.
To Next Page
Need help?
General
