13_10
To replace the gearbox oil proceed as follows:
1. Remove the cap «A», loosen cap «B» and drain the oil; when drainage is complete,
replace cap «B».
2. Pour some oil into the top hole and let the engine run for a few seconds; then, drain
the crankcase again.
3. Refill with new oil, periodically checking the level with the bar until the mark MAX
is reached.
WARNING
REPLACE THE OIL WHEN THE ENGINE IS WARM.
•
AN EXCESSIVE AMOUNT OF OIL CAN SPILL OUT AND DIRTY THE EN-
GINE.
WARNING
•
USED OIL CONTAINS SUBSTANCES HARMFUL TO THE ENVIRON-
MENT. FOR OIL REPLACEMENT, CONTACT ANY AUTHORISED PIAG-
GIO SERVICE CENTRE AS THEY ARE EQUIPPED WITH LAW-ABIDING
ENVIRONMENTALLY- FRIENDLY OIL DISPOSAL SYSTEMS
Recommended products
AGIP ROTRA MP 80W-90
Oil with specifications SAE 80W-90, API GL-5
Gearbox oil
Characteristic
Oil amount for gasoline version:
82
To Next Page
Loading...
Need help?
General
