Pioneer VS-60 User Manual

Operating Instructions
AUDIO/VIDEO SELECTOR
VS-60
Thank you for buying this Pioneer product.
Please read through these operating instructions and then
you will know how to operate your model properly. After
you have finished reading the instructions, put them away
in a safe place for future reference.
In accordance with the power and voltage requirements of
differing areas, the following model names are used to
designate models with differing electrical specifications.
KU, KC AC 120 volts
S, S/G, SS | AC 110, 120, 220, 240 volts (Switchable voltage)
NOTES:
¢ The model names are stamped on the packing case.
e These operating instructions are prepared on the basis of the KU
model, and they can be used for other models. Although the de-
sign of the power plug and the power outlet shown may differ from
the actual one, the operating procedures are the same.
POWER SUPPLY CORD
¢ This audio/video selector is equipped with a polarized alter-
nating current line plug (a plug having one blade wider than
the other). This plug will fit into the power outlet only one
way. This is a safety feature. If you are unable to insert the
plug fully into the outlet, try reversing the plug. If the plug
should still fail to fit, contact your electrician to replace
your obsolete outlet. Do not defeat the safety purpose of
the polarized plug.
¢ When the power cord or plug is damaged or frayed, unplug
this audio/video selector from the wall outlet and refer ser-
vicing to qualified service personnel.
¢ Do not overload wall outlets and extension cords as this
can result in fire or electric shock.
* NO GOOD x
IMPORTANT
WARNING: to preveNT FIRE OR SHOCK HAZARD,
DO
NOT
EXPOSE
THIS
APPLIANCE
TO
RAIN
OR
MOISTURE.
IMPORTANT NOTICE
[For U.S.A. and Canadian models]
The
serial
number
for
this
equipment
is
located
on
the
rear
panel.
Please
write
this
serial
number
on
your
enclosed
war-
ranty
card
and
keep
in
a
secure
area.
This
is
for
your
security.
LINE VOLTAGE SELECTOR SWITCH
The
line
voltage
selector
switch
is
located
on
the
bottom
of
the
cabinet
of
this
audio/video
selector.
Before
your
VS-60
is
shipped
from
the
factory,
the
switch
is
set
to
the
power
re-
quirements
of
the
VS-60's
destination.
Check
that
it
is
set
properly
before
plugging
the
power
cord
into
the
outlet.
If
the
voltage
is
not
properly
set
or
if
you
move
to
an
area
where
the
voltage
requirements
differ,
adjust
the
selector
switch
as
follows:
*
Provide
yourself
with
a
medium-sized
screwdriver.
Insert
the
tip
of
the
screwdriver
into
the
groove
of
the
selector
switch
and
turn
it
so
that
the
power
voltage
marking
of
your
area
points
to
the
Hole.
Medium size
screwdriver
VOLTAGE
SELECTOR
[For Canadian model]
CAUTION:
TO
PREVENT
ELECTRIC
SHOCK
DO
NOT
USE
THIS
(POLARIZED)
PLUG
WITH
AN
EXTENSION
CORD,
RECEPTACLE
OR
OTHER
OUTLET
UNLESS
THE
BLADES
CAN
BE
FULLY
INSERTED
TO
PREVENT
BLADE
EXPOSURE.
ATTENTION: pour prevenitR LES CHOCS ELEC-
TRIQUES
NE
PAS
UTILISER
CETTE
FICHE
POLARISEE
AVEC
UN
PROLONGATEUR
UNE
PRISE
DE
COURANT
OU
UNE
AUTRE
SORTIE
DE
COURANT,
SAUF
SI
LES
LAMES
PEUVENT
ETRE
INSEREES
A
FOND
SANS
EN
LAISSER
AUCUNE
PARTIE
A DECOUVERT.
The lightning flash with arrowhead, within an
equilateral triangle, is intended to alert the user of the
presence of uninsulated ‘dangerous voitage” within the
product's enclosure that may be of sufficient magnitude
to constitute a risk of electric shock to persons.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION:
TO PREVENT THE RISK OF ELECTRIC SHOCK, DO
NOT REMOVE COVER {OR BACK). NO USER-
SERVICEABLE PARTS INSIDE. REFER SERVIC-
ING TO QUALIFIED SERVICE PERSONNEL.
QPIONEER
The
exclamation
point
within
an
equilateral
triangle
is
intended
to
alert
the
user
of
the
presence
of
important
operating and maintenance (servicing) instructions in
the literature accompanying the appliance.

Pioneer VS-60 Specifications

General

Brand	Pioneer
Model	VS-60
Category	Recording Equipment
Language	English