Instr 9924828 Rev 02 2016-08 Page 2 of 3
REF
QTY PART DESCRIPTION
PART NUMBER
7 1 Main Strap
-
8 2 ITW Nexus Triglide Adjustment Buckle
-
9 1 Female Buckle Assembly
-
1 Instructions 9924828
TOOLS REQUIRED
No tools required.
IMPORTANT
Your ADJUSTABLE GAS CAN HOLDER KIT is exclusively designed for your vehicle. Please read the
installation instructions thoroughly before beginning. Installation is easier if the vehicle is clean and free of
debris. For your safety, and to ensure a satisfactory installation, perform all installation steps correctly in the
sequence shown.
ASSEMBLY TIME
Approximately 20 minutes
INSTALLATION INSTRUCTIONS
IMPORTANT
The maximum capacity of the tunnel of the
snowmobile is 6.8 Kg (15 lbs).
1. Insert four carriage bolts
q
in the tunnel grooves
of the snowmobile, two on each side.
2. Insert the main plates
t
into the tunnel, aligning
the bolts in the adjustment slots.
3. Insert the side plates
y
in the main plates
t
.
4. Install the four washers
w
and the four handles
e
,
do not tighten them firmly.
5. Install the male buckle
r
on the strap
u
. Install
the strap on the front and rear using the female
buckle assembly
o
into the slots of the main
plates
t
.
6. Place the can between the plates. Center it on the
tunnel and tighten the plates using the handles
e
.
To Next Page
Loading...
Need help?
General
