Polaris P945 User Manual

Page 6
English
3. Push base unit down (Figure 3) so the metal
handle frame is seated in the recess on the
underside of the base.
Figure 3. Connect Metal Frame to Base Unit
4. Slide the handnut over the tube and twist to
tighten onto base unit (Figure 4).
Figure 4. Twist Handnut to Secure Frame
 

6. Slide axle and hubcap piece through center of
wheel and attach to base unit. Snap locking clip
into place to secure wheel. Repeat to attach both

Figure 5. Snap in Support Blocks and Attach
Wheels
7. Slide the control unit base / caddy handle
attachment down over the metal tubing until it
snaps into place. (See Figure 6).
Figure 6. Attach Caddy Handle

Polaris P945 Specifications

General

Filter Type	Fine filter bag
Weight	19.5 lbs (8.8 kg)
Drive System	4-Wheel Drive
Type	Robotic
Pool Type	In-ground
Cable Length	60 ft (18.3 m)
Warranty	2 years
Cleaning Coverage	Wall, floor, and waterline
Cleaning Cycle	2.5 hours
Cleaning Time	2.5 hours