5. Adjust the beam to the desired position by loosening or tightening the bottom
screw
r
and moving the lamp to the appropriate height.
6. Adjust the beam to desired position. Repeat the procedure to adjust the other
headlight.
WARNING
Due to the nature of light utility vehicles and where they are operated,
headlight lenses become dirty. Frequently washing is necessary to maintain
lighting quality. Riding with poor lighting can result in severe injury or death.
BRAKE LIGHTS
When the brake pedal is depressed, the brake light comes on. Check the brake
light before each ride.
To check the brake lights, do the following:
1. Turn the key to the ON position.
2. Depress the brake pedal. The brake light should come on after about 0.4 in
(10 mm) of pedal travel. If the light doesn't come on, check the bulb.
FUSES
If the engine stops or will not start, or if you experience other electrical failures, a
fuse may need replacement. Locate and correct any short circuits that may have
caused the blown fuse, then replace the fuse. The fuse box is located under the
passenger side seat (Crew — rear passenger side seat). Spare fuses are
provided in the fuse box.
If you suspect that a fuse or relay may not be working properly, your dealer can
assist.
124
MAINTENANCE
To Next Page
Loading...
Need help?
General
