88
MAINTENANCE
Engine Oil
Oil and Filter Change
Always check and change the oil at the intervals outlined in the Periodic
Maintenance Chart beginning on page 79. Always change the oil filter
whenever changing oil.
The engine drain plug is located
on the bottom of the crankcase.
1. Position the vehicle on a level
surface. Place the
transmission in PARK. Apply
the brakes.
2. Start the engine. Allow it to
idle for two to three minutes.
Stop the engine.
3. Clean the area around the
drain plug.
CAUTION! Hot oil can cause burns
to skin. Do not allow hot oil to contact
skin.
4. Place a drain pan beneath
engine crankcase and remove
the drain plug.
5. Allow the oil to drain
completely.
6. Install a new sealing washer
on the drain plug.
Tip: The sealing surfaces on drain
plug and crankcase should be
clean and free of burrs, nicks or
scratches.
7. Reinstall the drain plug. Torque to 11-13 ft. lbs. (14.5-17.5 Nm).
To Next Page
Loading...
Need help?
General
