Poulan Pro PPBP30 User Manual

1-2 . SPECIFICATIONS
ENGINE
Engine Type .Air-cooled, 2-cycle
Displacement.(30 cc) {1.63 cu in.)
Idle Speed RPM.3 400 - 4,400 rpm
Operating Speed RPM.9 000 rpm
Ignition Type.Electronic
Ignition Switch .Rocker switch
Spark Plug Gap.0.026 in.{0.635 mm)
Lubrication .Fuel/oil mixture
Fuel/Oil Ratio.40: i
Carburetor .with primer
Muffler .Baffle with guard
Fuel Tank Capacity.i8.5oz (550ml)
BLOWER
Throttle Control .Finger-tip trigger
Blower Velocity.up to 180 mph
Blower Air Output.up to 400 cfm
Approximate Unit Weight (No fuel) .14.3 lbs
2 - SAFETY PRECAUTIONS
2-1, WHAT TO DO
READ YOUR USER MANUAL AND ALL
SUPPLEMENTS (IF ANY ENCLOSED)
THOROUGHLY BEFORE OPERATING YOUR
UNIT.
1. WEAR CLOSE FITTING, TOUGH WORK
CLOTHING that will provide protection, such
as long slacks or trousers, safety work shoes,
heavy duty work gloves, hard hat, a safety
face shield, or safety glasses marked 287 and
approved hearing protection.
2. REFUEL IN A SAFE PLACE, Open fuel cap
slowly to release pressure which may have
formed in fuel tank. Always wipe unit of fuel or
oil spills before starting. To prevent a fire
hazard, move at least 10 feet (3 meters) from
fueling area before starting.
3. COMPLY WITH ALL FIRE PREVENTION
REGULATIONS. COMPLIANCE WITH ALL
LOCAL, STATE, OR FEDERAL LAWS IN THE
UNITED STATES IS THE USER'S
RESPONSIBILITY.
SPECIAL NOTICE: This unit is equipped with
a temperature limiting muffler and spark
arresting screen which meets the requirements
of CaiiforniaCodes 4442 and 4443.AII
U.S.forest land and the states of California,
Idaho,Maine,Minnesota,New Jersey,Oregon,
and Washington require by law that many
internal combustion engines be equipped with
a spark arresting screen. If you operate in a
locale where such regulations exist, you are
legally responsible for maintaining the
operating condition of these parts.Failure to do
so is a violation of the Saw. For normal
homeowner use, the muffler and spark
arresting screen will not require any
service.After 50 hours of use,we recommend
that your muffler be serviced or replaced by an
authorized service dealer.
4. TURN UNIT OFF before setting It down, and
also before installing or removing attachments,
5. KEEP ALL SCREWS AND FASTENERS
TIGHT and the unit in good operating
condition. Never operate this equipment if it is
improperly adjusted or not completely and
securely assembled.
6. KEEP HANDLES DRY, clean and free of fuel
mixture.
3

Poulan Pro PPBP30 Specifications

General

Brand	Poulan Pro
Model	PPBP30
Category	Blower
Language	English