Front wheel steering adjustment:
Your trolley will already be pre-set to run
straight. If you find your trolley tracking to the left or right you can re-adjust
this by releasing the front wheel lever and rotating the adjustment roller. Rotate up to
make your trolley track more to the LEFT and rotate down to track more to the RIGHT.
Once you are happy the trolley is running straight re-apply the lever to lock in position.
FW3 Controls:
Once your battery is connected your trolley will be ready to use.
The control functions are detailed below:
Central control knob:
Turn to control the speed of the trolley in normal operation. Press to
pause and resume your selected speed.
Power Indicator:
Displays whether power is being applied to the drive system. (on/off)
Thank you for purchasing the new PowaKaddy FW3. We hope you enjoy your new trolley and welcome your feedback and
comments. Please read these instructions carefully. Battery care is very important, please refer to the back page of this manual
for battery care instructions.
When you receive your new Powakaddy FW3 you will have the following:
1 x Trolley | 1 x Battery (lead acid or lithium) | 1 x Charger | 2 x Wheels | 1 x Instruction pack
IMPORTANT-
you must fully charge your battery for a minimum of
12 hrs before using your trolley. Always recharge your battery within
24 hrs of use. Failure to do so could reduce the life of your battery.
Note:
if you have purchased a Lithium or Lithium Extended product the battery is stored in the frame.
Remove the battery and activate using the isolation switch located on the underside of the battery.
(See image 2 for battery removal)
+ -
12h
Power Indicator
Central Control Knob
1
2
3
4
Maintenance:
Your PowaKaddy trolley is simple to maintain. Follow these steps for optimal performance.
Store in a dry, protected place.
Never jet wash your trolley or immerse it into water. Avoid using detergents, oils or solvents to clean your trolley. Wipe using a
damp cloth and always dry your trolley if used in wet conditions.
Occasionally remove the wheels and apply grease to the axle and moving parts.
Your serial number can be found on the underside of the central tube.
Off
On
Fit the wheels by pressing the yellow release clip and pushing onto the axle until the clutch is engaged. Note: the wheels can be
locked into two positions; push onto the inner groove to engage drive. The outer groove can be used when drive is not required.
To open, slide the main lock (highlighted below) forward to release the handle latch and open as shown below.
1
A
B
C
1
2
Plug’n’Play Battery System: Once your battery is charged
and trolley assembled connect your battery as shown.
Engage the rear of the battery first.
Press the front until the battery clips into position.
The trolleys power will automatically be connected.
To remove the battery depress the front latch (highlighted) and
lift the battery out. The lithium battery operates in the same way.
Note: The lithium battery can be stored within the tray for
transportation and storage.
Please ensure you de-activate the battery using the red
isolation switch located on the underside. Leaving your
battery in the on (1) position could lead to your battery
discharging or trolley activating during transportation.
PLUG’n’ P L A Y
TM
1
2
2
0 1
To Previous Page
Loading...
Need help?
General
