Front wheel steering adjustment:
Your trolley will already be pre-set to run
straight. If you find your trolley tracking to the left or right you can re-adjust
this by releasing the front wheel lever and rotating the adjustment roller. Rotate up to
make your trolley track more to the LEFT and rotate down to track more to the RIGHT.
Once you are happy the trolley is running straight re-apply the lever to lock in position.
ADF Automatic Distance Function:
The ADF function is a convenient way of sending your trolley a set distance. For example
when you are approaching a green you can send the trolley towards the next tee if the
route allows. Please note it is not recommended to send your trolley unattended over
steep or rough terrain. To activate press and hold the Central Control Knob until A appears
on screen. Rotate the control knob to select from:
1 = 15Yrds 2 = 30Yrds 3 = 45Yrds.
To start the function press the control knob.
WARNING!
Before using the ADF function please ensure the route is clear from any
obstacles. In an emergency the trolley can be stopped by pressing the control knob.
FW5 Controls:
Once your battery is connected your trolley will be ready to use.
The control functions are detailed below:
Central control knob:
Turn to control the speed of the trolley in normal operation. Press to
pause and resume your selected speed.
USB Charging Port:
Located under the screen. Open the hatch to charge GPS & mobile
devices. The output is rated to 5v/500mA suitable for most USB devices.
Battery Guage:
Displays your batterys life
Power Indicator:
Displays whether power is being applied to the drive system. (on/off)
Thank you for purchasing the new PowaKaddy FW5. We hope you enjoy your new trolley and welcome your feedback and
comments. Please read these instructions carefully. Battery care is very important, please refer to the back page of this manual
for battery care instructions.
When you receive your new Powakaddy FW5 you will have the following:
1 x Trolley | 1 x Battery (lead acid or lithium) | 1 x Charger | 2 x Wheels | 1 x Instruction pack
IMPORTANT-
you must fully charge your battery for a minimum of
12 hrs before using your trolley. Always recharge your battery within
24 hrs of use. Failure to do so could reduce the life of your battery.
Note:
if you have purchased a Lithium or Lithium Extended product the battery is stored in the frame.
Remove the battery and activate using the isolation switch located on the underside of the battery.
(See image 2 for battery removal)
+ -
12h
Battery Guage Power Indicator
Central Control Knob
Power setting
1
2
3
4
Maintenance:
Your PowaKaddy trolley is simple to maintain. Follow these steps for optimal performance.
Store in a dry, protected place.
Never jet wash your trolley or immerse it into water. Avoid using detergents, oils or solvents to clean your trolley. Wipe using a
damp cloth and always dry your trolley if used in wet conditions.
Occasionally remove the wheels and apply grease to the axle and moving parts.
Your serial number can be found on the underside of the central tube.
1 = 15Yrds 2 = 30Yrds 3 = 45Yrds.
Press to start
3 secs
1
2
3
Low
High
Mid
Off
On
Fit the wheels by pressing the yellow release clip and pushing onto the axle until the clutch is engaged. Note: the wheels can be
locked into two positions; push onto the inner groove to engage drive. The outer groove can be used when drive is not required.
To open, slide the main lock (highlighted below) forward to release the handle latch and open as shown below.
1
A
B
C
1
2
Plug’n’Play Battery System: Once your battery is charged
and trolley assembled connect your battery as shown.
Engage the rear of the battery first.
Press the front until the battery clips into position.
The trolleys power will automatically be connected.
To remove the battery depress the front latch (highlighted) and
lift the battery out. The lithium battery operates in the same way.
Note: The lithium battery can be stored within the tray for
transportation and storage.
Please ensure you de-activate the battery using the red
isolation switch located on the underside. Leaving your
battery in the on (1) position could lead to your battery
discharging or trolley activating during transportation.
PLUG’n’ P L A Y
TM
1
2
2
0 1