5
35. Computer USB Contacted Jack
Used USB cable line to contact with computer & mixer. Mixer could be play the computer audio and computer could be
recording the mixer output audio.
36. USB Port
USB: can be play through U-DISK
37. MP3/BT Command
STOP: Press shortly to stop playing. Press for seconds for recording, also press 2 seconds to stop recording.
PREV / NEXT: Turning the program control.
PLAY: Press the program control knob.
REP: Repeating of single track or all tracks.
38. MP3 EQ
Two-band equalizer adjusts the level if the two bands MP3 player.
39. Phantom +48V
This switch toggles phantom power on and off. When the switch is on the mixer supplies +48V phantom power to all
channels that have XLR input jacks. Turn this switch on when using one or more phantom-powered condenser
microphones.
40. 48V Indicator
The red LED lights up when phantom power is switched on. Phantom power is required to operate condenser
microphones
41. Power indicator
This indicator lights when the mixer power is on.
42. VU-Meter
Displays the signal of output.
NOTE: The "0" segment corresponds to the nominal output level. The peak indicator lights up red when the output
reaches the clipping level.
43. EQ Switch
Use this switch to activate the graphic equalizer.
44. PFL indicator
When open the monitor, PFL is lighting.
45. Headphone Input
6.3mm (¼”) input jack for connecting a headphone.
46. Sub to Main Switch
If this switch is on, the mixer send the signals processed by the Sub faders onto the stereo bus.
47. Sub Fader 1-4
Adjusts the signal level sent to the Sub Out (1-4 Jacks).
48. Main Mix Fader
You use the high-precision quality faders to control the output level of the main mix.
To Next Page
Loading...
Need help?
General
