1.3 Install the body
1
）
Move the machine with installed heat pipe and fittings before the
window, and the distance between the body and walls or other objects
shall be least 50 cm (as shown in Fig.4).
Figure4
2
）
Elongate the exhaust pipe and snap the flat end of the exhaust
pipe joints into the hole of the window sealing plate assembly (as
shown in Fig.5 and Fig.6) .
Notes
：
1.The flat end of the exhaust pipe joints must be snapped into
place.
2.
The pipe cannot be distorted nor has substantial turning (greater
than 45
°
). Keep the ventilation of the exhaust pipe not blocked.
Figure 5 Figure 6
Important notice:
The length of the exhaust hose shall be 280~1,500mm, and this
length is based on the specifications of the air conditioning. Do not
use extension tubes or replace it with other different hoses, or this
may cause a malfunction. Exhaust host must be not blocked;
otherwise it may cause overheating.
To Next Page
Loading...
Need help?
General
