Start
Start Button: press more than 2sec to Start/Off the battery module.
ADD Switch
ADD Switch: 4 ADD switches.
Dipl
to definite different baud rate
"OXXX"
setup the bond rate 1 15200, and "1
XXX"
setup the baud rate
9600. The setting will be active only after restart the battery.
Every battery module needs to change the dip switch to set the RS485
baud rate.
In the group, all the battery settings shuold be the same.
1
0
supervise 19
tiple battery
0
1
h: Single battery group's master battery should setup as this.
2nd: 2nd battery group's master battery should setup as this.
4th: 4th battery group's master battery should setup as this.
6th: 6th battery group's master battery should setup as this.
Console
Console Communication Terminal: (RJ
ll
port) follow RS232 protocol, for manufacturer or
professional engineer to debug or service.
L 0/1 I RS485
Link Port 0/1 or RS485 Communication port follow RS485 protocol, for communication between
master batter and host equipment. It connect all batteries as a group.
To Next Page
Loading...
Need help?
General
