Qlogic SANbox 5000 Series Instructions

SANbox
®
5000/9000 Series Switch Stacking Cable Instructions
2 50326-05 A
0
Copyright© 2006 QLogic Corporation
SANbox is a registered trademark of QLogic Corporation
Connect SANbox 5000 Series Switches
Using an XPAK-XPAK connector, install the cable connectors with the circuit
board toward the mid line of the respective switch faceplates. The cable connector
will fit only one way. When installing the 3-inch XPAK cable, insert the cable
connectors into the10-Gbps ports at the same time as shown.
Connect SANbox 5000 and 9000 Series Switches
To connect a SANbox 5000 Series switch and a SANbox 9000 Series switch, use
an XPAK-X2 cable. Install the XPAK connector in the SANbox 5000 switch port
with the circuit board toward the mid line of the switch. Install the X2 connector in
the SANbox 9000 switch port with the circuit board on the left.
To connect two SANbox 9000 switches, using an X2-X2 cable. Install the cable
connectors in the respective switch ports with the circuit boards on the left. The
cable connector will fit only one way.
L
AL A L AL
ALA
L
A
L
A
LA
1
6
L
A
1
7
L
A
1
8
L
A
19
L
A
L
AL A L AL
ALA
L
A
L
A
LA
1
6
L
A
1
7
L
A
1
8
L
A
19
L
A
Circuit Board

Qlogic SANbox 5000 Series Specifications

General

Brand	Qlogic
Model	SANbox 5000 Series
Category	Switch
Language	English