SCUBA TECTOR PRO
The Quest Scuba Tector Pro follows on the success of the Quest Scuba Tector. The Scuba Tector Pro features a foldable,
interchangeable search coil, unique dual-hinge joint, extendable handle, larger battery capacity and a powerful pulse
induction system. All these features make the Scuba Tector Pro the ultimate detector for beach or underwater use.
Interchangeable search coil and the extendable shaft need to be purchased seperately and are not included. How you can
change the coil is explained when buying the new coil.
PLEASE READ CAREFULLY BEFORE DETECTING
•
This detector is waterproof up to 60M/200FT. It can withstand immersion in 60M/200FT of water for 30 minutes.
•
Please do not pull the coil cable.
•
Install the anchor ring and attach the lanyard to not lose the detector, especially while detecting under water.
•
Make sure the battery cap thread and O rings are free of dust, mud, sediment, etc. Always remember to keep
the end cap thread and O-rings lubrcited with silicone grease to maintain a tight seal.
•
Before searching under water or cleaning the detector, make sure that the battery cap is
secured tightly
, so that
no water can get in.
•
Always wash your detector in fresh water after each dive. Do not use any chemical cleaners and solvents for
cleaning and/or for any other purpose. Wipe or air the detector dry thoroughly before storing or charging.
•
Always Store your detector fully charged.
•
Do not store the detector under extremely low or high tempertures for extended periods. (Storage Temperature:
-20 to 60 °C)
1
To Next Page
Need help?
General
