Quincy Compressor QT-54 User Manual

Page 3
This compressor is extremely top heavy.
Unless otherwise noted, it must be bolted to
the oor with vibration pads before
operating to prevent equipment damage,
injury or death. DO NOT tighten bolts
completely as this may cause stress to the
tank welds. See Illustration 1a.
Never use plastic (PVC) pipe for
compressed air. Serious injury or death
could result.
Never use the shipping skid for
mounting the compressor.
Electric compressors are not suitable
for outdoor installation.
Gasoline compressors must be operated
outdoors, sheltered from the weather.
Never install a shut o󰀨 valve between the
compressor pump and tank.
Personal injury and/or equipment damage
could occur.
DO NOT secure compressor with toggle
bolts into drywall. Drywall sheeting or
plaster will not support the weight of the
compressor and serious injury could
result.
To reduce the risk of a dangerous
environment
1. Keep work area well lit.
2. Operate compressor in a well-ventilated area
free from ammable liquids and vapors.
3. Operate compressor in a ventilated area so
that compressor may be properly cooled and
the surrounding air temperature will not be
more than 100°F (38°C).
4. Never use a compressor in a wet
environment.
5. Protect material lines and air lines from
damage or puncture. Keep hose and wires
away from sharp objects, chemical spills, oil,
solvents and wet oors.
When installing or moving the compressor
WARNING
WARNING
CAUTION
NOTICE
NOTICE
WARNING
WARNING
Always Shut o gas valve before moving
gas drive compressors
6. A minimum clearance of 18 inches (46cm)
between the compressor and a wall is
required because objects could obstruct
airflow.
7. The compressor should be located where
it can be directly wired to a circuit breaker.
Based on design, certain compressors
should be wired by a qualied electrician.
8. Never store ammable liquids or gases in
the vicinity of an operating compressor.
9. DO NOT locate the compressor air inlet near
steam, paint spray, sandblasting areas or
any other source of contamination.The
debris could damage the motor or the pump.
Flat
Compressor
Washer
Leg
Shim
Floor
Vibraton Pad
(If Necessary)
Lag Bolt
Illustration 1a
Before each use
Inspect your work area
1. Keep work area clean. Cluttered areas and
benches invite accidents.
2. The floor must not be slippery from liquids
or dust.
Inspect your compressor
1. To reduce the risk of injury from accidental
starting, turn the switch o󰀨 and disconnect
power.
2. If any part is missing, bent or broken in
any way, or any electrical part does not
work properly, keep the compressor o󰀨 and
disconnect power. DO NOT use if defect is
found.
3. Check hoses for weak or worn condition
before each use, making certain all
connections are secure. DO NOT use if a
defect is found.

Quincy Compressor QT-54 Specifications

General

Brand	Quincy Compressor
Model	QT-54
Category	Air Compressor
Language	English