Use Dynamo Power
Your radio comes with a 3.6V, 300 mAh, Ni-
MH rechargeable battery pack that can be
recharged using the dynamo crank.
1. On the back panel of the radio, switch
DYNAMO/
BAT TERY to
DYNAMO.
2. Lift the crank
and rotate it in
either direction.
The RECHARGE
Indicator lights
when charging.
Charge time
depends on
cranking rate and
duration.
For example, turning the crank at about
2 turns per second for about 90 seconds
should power the radio for about 10
minutes. If playback time decreases to less
than 5 minutes at this cranking rate, replace
the rechargeable batter y pack.
AM/FM/Weather Band
Crank Radio
We hope you enjoy your AM/FM/Weather
Band Crank Radio from RadioShack. This radio
receives AM, FM, and all National Oceanic and
Atmospheric Administration (NOAA) Weather
Radio channels. Please read this user's guide
before using your radio.
Package Contents
• Crank Radio
• Rechargeable Battery Pack
• User’s Guide
Specifications
AM .............................................................. 530 – 1710 kHz
FM ...................................................................88 – 108 MHz
Weather (WX) .................................162.4 – 162.55 MHz
Power Output (at 10% THD) ............................100 mW
Power .......................................................... 3.6V, 100mAh
.............. Ni-Mh rechargeable battery pack (included)
...................................... 3 AA batteries (not included) or
.....................5VDC Micro-USB adapter (not included)
Antenna ........................................... AM: built-in antenna
..........................................FM/WX: telescoping antenna
Speaker ......................................................... 3 in. (76 mm)
.............................................................. Impedance: 8 ohm
Speci ficati ons are subjec t to change an d improvement
with out notice. Ac tual produc t may vary fro m the images
found i n this document.
Power Your Radio
IMPORTANT! Always inser t the rechargeable
battery pack when you use your radio. Insert the
battery pack plug into the connector, then place
the battery pack in the slot.
You can power your radio in three ways:
• Dynamo power using the included
rechargeable battery pack
• Three AA batteries (not included)
• 5V DC Micro-USB adapter (not included)
Install Batteries (Optional)
Insert 3 AA
batteries (not
included) into
the battery
compartment
matching
the marked
polarity. Switch
DYNAMO/
BAT TERY to
BAT TERY.
Battery Notes:
• Dispose of batteries promptly and properly.
Do not burn or bury them.
• Use only fresh batteries of the required size
and type.
• Do not mix old and new batteries, dierent
types of batteries (alkaline or rechargeable),
or rechargeable batteries of dierent
capacities.
• If you do not plan to use the radio for a long
time, remove the batteries. Batteries can
leak chemicals that can damage electronic
parts.
Use a Micro USB Adapter (Optional)
You can listen to the radio and
charge the radio’s battery pack at
the same time. Connect a 5V DC
Micro-USB adapter (not supplied)
to the DC IN jack. Using this
method, the battery pack requires
about 12 hours to fully charge.
Notes:
• Your adapter must supply 5V DC and deliver
at least 50 0mA. Its plug must t your radio’s
5V jack. Using an adapter that does not meet
these specications could damage your radio
or adapter.
• Batteries should NEVER be left unattended
while charging. Only adults should charge
the batteries. Use caution when using the
charger to avoid electric shock.
• Do not disassemble the charger or batter y
pack. Incorrect assembly can result in risk of
electric shock or re.
ALERT
indicator
RECHARGE
indicator
BAND
• Select AM/FM/W X band.
• Enter/Exit time setting mode.
SCAN
Scan for stations.
UP/ DOW N
Tune stations.
VOL+/VOL–
• Adjust the volume.
• Set the clock ti me.
Dynamo
crank
POWER
ALERT
DC IN
DYNAMO/
BAT TE RY
2000655_UG_EN_071114.indd 1-7 7/29/2014 4:19:21 PM
To Next Page
Need help?
General
