CB-500 CB Radio
5
keys on the unit or
UP
/
DN
keys on the
microphone for 7 seconds or until a beep sounds to start CB SCAN function.
When the CB SCAN function is active, "
" blinks on the LCD.
(2)
Short press / keys on the unit or
UP
/
DN
keys on the microphone
to change the scan direction.
(3)
Short press
key to change mode, short press
PTT
switch to exit
3.8
Scan Function
※
scan.
CB Channels Scan (very long press)
(1)
In CB mode, press and hold
(1)
/
First press key to choose the first programmed emergency channel,
"
" appears on the LCD.
key to choose the second programmed emergency
(2) Second
" appears on the LCD.
press
channel, "
(3) Third press
key to return to last used normal channel.
Note: The default Emergency Channels are channel
and channel
See Menu- Emergency Channel Set, page 11 for Emergency Channel
configuration.
※MENU (long press)
Long press
3.7
Emergency Channels ~ MENU ~ VOX
※
key to enter the Menu.
Emergency Channels (short press)
※
VOX (PTT + EMG)
(1) Press and hold
the
PTT switch.
(2)
Short press key to activate or deactivate the VOX function, " "
appears on the LCD when the VOX function is active.
※Scan Skip (long press - only valid if
SKIP memory, you can enter the MENU and select the
menu option.
the SCAN function is activated)
This function allows you to skip a channel found by the SCAN function. When the
scan stops on an unwanted channel, press and hold the key to store this
channel in the SCAN SKIP memory. The channel will no longer be scanned.
Note: If you want to memorize/erase the current channel from the SCAN
To Next Page
Loading...
Need help?
General
