ST70 Pilot – setting your preferences
Choosing data units
When an ST70 pilot is connected to SeaTalk
ng
or SeaTalk
2
, you can use it to select the units
in which data is displayed throughout the system. A range of imperial, metric and nautical
units is available.
Use the procedure on this card to choose the units you want.
Choosing data units
1. Select Main Menu
Press
MENU
to display the
Main Menu
then use
<
or
>
to scroll to
Display Settings
.
Press
ENTER
to display the
Display Settings
menu.
2. Initial actions
At the
Display Settings
menu, use
<
or
>
to scroll to the
Units
option.
3. Units summary
Press
ENTER
to show a summary of the Units currently
applied.
Press
ENTER
to select the second
Units
summary page.
If you do not want to change any units, press
CANCEL
.
4. Units select menu
If you want to change any of the units, press
ENTER
, to go to
the
Units
select menu.
5. Select the units you want to change
Use
<
or
>
to scroll to the required data type (e.g.
Wind
Speed Units
)
Press
ENTER
to go to the
Units
edit box.
Press ENTER to select.
Display Settings
Units
i
D10839-1
Change the default unit settings.
D9439-1
i
Speed KTS
Distance NM
Depth FT
Wind Speed
KTS
Heading M
These are your current settings.
Units
Press ENTER to continue
Flow Rate
G/H
Temperature
C
o
D
9
4
4
2
-1
i
i
Press ENTER to accept
Wind Speed Units
KTS
Use < & > to adjust.
CANCEL exits without saving.
continued ...
Card
8
To Next Page
Loading...
Need help?
General
