1
Need Help? Visit our website at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00 AM - 5:00 PM PST.
E100
MOTOR REPLACEMENT
INSTRUCTIONS
PA R T# W13111612 0 3 0
Using a Phillips screwdriver, remove the six (6) screws
on the deck cover (circled in the image below).
A. Phillips screwdriver
B. 8 mm wrench
C. Small pointy object
CAUTION: To avoid potential shock or other injury, turn power switch OFF and disconnect charger before performing any
assembly or maintenance procedures. Failure to follow these steps in the correct order may cause irreparable damage.
Using an 8 mm wrench, remove the two (2) lock nuts at
the back of the deck cover circled in the image below).
Step 1
Required Tools: (Not included)
WARNING
Step 2
To Next Page
Need help?
General
