6
Program for VCR—
Direct Entry Method
VCR
1. Manually turn on the VCR.
2. Locate the enclosed VCR Code List.
Find your brand of VCR.
N
ote:
I
f your brand isn’t listed, use one
of the Code Search methods to program
this remote control
(See Code Search
on page 9).
3. Press and hold the CODE SEARCH
key until the indicator light illuminates.
Then release the CODE SEARCH key.
4. Press and release the VCR key.
The indicator light blinks and then
remains lit.
5. Use the number keys on the remote to
enter the first code listed for your brand.
After you enter a valid four-digit
code, the indicator light turns off.
Note: If you enter an invalid code,
the LED will flash rapidly for 2
seconds. Start over at step 3.
6. Aim the remote at the VCR. Press
the ON•OFF key. If your VCR turns
off, you have found the correct code.
7. Enter the code in the box provided
on this page for future reference.
8. If your VCR doesn’t turn off, repeat
steps 3-6 above, entering the next
code for your brand.
If none of the codes work or your
brand is not listed, use one of the
Code Search methods to program this
remote (See Code Search on page 9).
For a description of each key on
the remote control, refer to the Key
Descriptions section on page 3-4.
In order for the 4-component universal remote to control
your VCR, you must program it with the code that matches
your VCR. These instructions explain the preferred method
of programming the remote—the Direct Entry method.
ON•OFF
(
BLINK)
(OFF)
CODE
SEARCH
INDICATOR
LIGHT
VCR CODE
To Next Page
Loading...
Need help?
General
