Digital Signal
Preamplier
For Outdoor Antennas
The TVPRAMP12E is designed specically to improve the
performance of outdoor antennas in low signal strength areas,
extending antenna range to give you the most channels and best
reception possible. The TVPRAMP12E is engineered for digital
signals, so it outperforms old preamps made for analog.
Preamplier Installation
IMPORTANT: Do not plug in the power adapter until all connections
are completed (step 8).
1. Set the FM TRAP switch on the bottom of the
preamplier.
The preamplier’s FM Trap is set
to ON by default. If you would
like to turn it o, use a small
athead screwdriver to set this
Position the U-bolt on the
antenna mast where you want
to mount the preamplier. Make
sure you mount it within easy
reach.
Put the preamplier on the
U-bolt as shown. Then place
the washers on both ends, followed by the nuts.
NOTE: For best results, mount the preamplier as close to
the antenna as possible.
FM
5. Connect the other end(s) of the antenna downlead(s)
to the preamplier.
Connect the downlead cable
from the preamplier to the TO
ANT jack on the power injector.
Make sure your TV or digital
converter box is turned o. Then
attach the power injector’s built-
in coaxial cable to the antenna
input jack on your TV or digital
converter box.
8. Plug the power injector’s power cord into a standard
wall outlet or surge protector.
9. Turn your TV or digital converter box back on and
rescan for channels.
From antenna
o TV/digital converter box
WARNING: TO PREVENT
FIRE OR SHOCK HAZARD,
DO NOT EXPOSE POWER
SUPPLY SECTION OF THIS
APPLIANCE TO RAIN OR
MOISTURE.
3. Slide the weather boots over the antenna downlead.
Attach F-connectors to the
coaxial cable if necessary.
7. Connect to the power injector and TV/digital
converter box.
TVPRAMP12E User’s Guide
switch to OFF. (The switch is protected by a weatherproof cover
that you’ll have to remove rst.)
NOTE: For best perfomance, keep the FM trap in the ON
position. If you use your antenna for FM as well as for TV
broadcasts, switch the FM trap o. Please note, however,
that switching the FM trap o may aect TV reception
performance.
IMPORTANT: Make sure the weatherproof cover for this
switch is back in place before you mount the preamplier to
your antenna mast.
2. Mount the preamplier to your antenna mast.
4. Connect the antenna downlead to your antenna.
Leave enough slack in the cable to form a drain loop.
You can secure the coaxial downlead to the mast with
weatherproof tape or cable ties.
Slide the weather boot over the cable connector and boot collar
on the antenna.
6. Connect the preamplier
downlead to the
preamplier.
Connect the downlead to the
OUTPUT/POWER jack on the
preamplier.
Slide the weather boot over the
cable connector and boot collar
on the preamplier.
The power injector must be
plugged in INSIDE your house.
Note: This power unit should
be plugged in so that it stays
vertical or lies at.
© 2019 VOXX Accessories Corporation
www.rcaaudiovideo.com
Trademark(s) Registered
Printed in China
TVPRAMP12E IB 01
Connect the downlead to the ANTENNA INPUT jack on the
preamplier.
Slide the weather boot over the cable connector and boot collar
on the preamplier.
12 Month Limited Warranty
Voxx Accessories Corporation (the “Company”) warrants to the original retail purchaser of this product
that should this product or any part thereof, under normal use and conditions, be proven defective in
material or workmanship within 12 months from the date of original purchase, such defect(s) will be
repaired or replaced with new or reconditioned product (at the Company’s option) without charge for
parts and repair labor.
To obtain repair or replacement within the terms of the warranty, the product is to be delivered with
proof of warranty coverage (e.g. dated bill of sale), specication of defect(s), transportation prepaid, to
an approved warranty station. For the location of the nearest warranty station to you, call toll-free to our
control oce: 1-800-645-4994.
This Warranty is not transferable and does not cover product purchased, serviced or used outside the
United States or Canada. The Warranty does not extend to the elimination of externally generated static
or noise. This Warranty does not apply to costs incurred for installation, removal or reinstallation of the
product, or, if in the Company’s opinion, the product has been damaged through acts of nature, alteration,
improper installation, mishandling, misuse, neglect, or accident. This Warranty does not cover damage
caused by an AC adapter not provided with the product.
THE EXTENT OF THE COMPANY’S LIABILITY UNDER THIS WARRANTY IS LIMITED TO THE REPAIR
OR REPLACEMENT PROVIDED ABOVE AND, IN NO EVENT, SHALL THE COMPANY’S LIABILITY
EXCEED THE PURCHASE PRICE PAID BY PURCHASER FOR THE PRODUCT.
This Warranty is in lieu of all other express warranties or liabilities. ANY IMPLIED WARRANTIES,
INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR
PURPOSE, SHALL BE LIMITED TO DURATION OF THIS WARRANTY. ANY ACTION FOR BREACH OF
ANY WARRANTY HEREUNDER, INCLUDING ANY IMPLIED WARRANTY, MUST BE BROUGHT WITHIN
A PERIOD OF 24 MONTHS FROM THE DATE OF ORIGINAL PURCHASE. IN NO CASE SHALL THE
COMPANY BE LIABLE FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES WHATSOEVER. No
person or representative is authorized to assume for the Company any liability other than expressed herein
in connection with the sale of this product.
Some states/provinces do not allow limitations on how long an implied warranty lasts or the exclusion
or limitation of incidental or consequential damage so the above limitations or exclusions may not apply
to you. This Warranty gives you specic legal rights and you may also have other rights which vary from
state/province to state/province.
To Next Page
Need help?
General
