Rheem MPi Series User Manual

COMMISSIONING
37
SYSTEM RESET
To reset the system and override the forty five (45) minute start delay:
1. Press and hold the red controller reset button for two (2) to three (3)
seconds until both the green and red LEDs display a solid glow. Release
the button.
The reset button is located on the front left corner of the underside of the
controller box.
2. The green LED will flash rapidly for three (3) seconds, then the heat pump
will commence its heating start-up cycle. A series of 2 or 3 x green flashes
will commence.
reset
button

Rheem MPi Series Specifications

General

Brand	Rheem
Model	MPi Series
Category	Heat Pump
Language	English