After installing the device certificate on the machine, configure the electronic signature using Web Image
Monitor. The configuration procedure is the same regardless of whether you are using a self-signed
certificate or a certificate issued by a certificate authority.
1. Open a Web browser.
2. Enter "http://(the machine's IP address or host name)/" in the address bar.
When entering an IPv4 address, do not begin segments with zeros. For example: If the address is
"192.168.001.010", you must enter it as "192.168.1.10" to connect to the machine.
The top page of Web Image Monitor appears.
3. Click [Login].
The network administrator can log in.
Enter the login user name and login password.
4. Click [Configuration], and then click [S/MIME] under "Security".
The S/MIME settings page appears.
5. Select the digest algorithm to be used in the electronic signature next to "Digest Algorithm"
under "Signature".
6. Select the method for attaching the electronic signature when sending e-mail from the
scanner next to "When Sending E-mail by Scanner" under "Signature".
7. Select the method for attaching the electronic signature when forwarding stored documents
next to "When Transferring Files Stored in Document Server (Utility)" under "Signature".
8. Click [OK].
The settings for the S/MIME electronic signature are enabled.
9. Click [Logout].
5. Securing Information Sent over the Network or Stored on Hard Disk
116
To Next Page
Loading...
Need help?
General
