3. On the Service Mode screen, click [Fuser SC Reset]. This releases the fatal fusing error which locks
the machine.
4. Select "On" for Fuser SC Detect. This setting shuts down the machine if three successive paper jams
occur in the fusing unit.
SC Tables
SC Table Key
SC codes are assigned a level of severity (A, B, C, D) based on the table below. These letters appear in
the 3rd column of the SC tables below.
Level Definition/ Reset Procedure
A
The machine is disabled due to a problem in the fusing unit, electrical component, or
firmware. The operator cannot operate the machine.
• This is a fatal error. The machine requires immediate servicing by a service
technician.
•
After solving the problem Fuser SC Reset must be executed to release the machine
for normal operation.
B
These SC codes disable only the features that use the defective item. Normally, the user
does not see these SC codes, but the SC code is displayed in the Error History box of the
Service Mode screen.
• Cycle the machine off/on with the main power switch".
Service Calls
203
To Next Page
Loading...
Need help?
General