1
Firmware Update Instruction Manual
This manual explains the procedures for downloading the CX2 firmware from the Ricoh website
and updating the camera’s firmware.
Perform the following operations to update the firmware.
1. Check the current version of the firmware
Caution
Before updating, be sure to check the firmware version through the following method. If the installed firmware is the latest
version, there is no need to update.
1. Make sure that the camera’s power is turned off.
2. While pressing the ADJ./OK button @ (1), hold
down the 6 (Playback) button (2) for 2-3 seconds.
• The firmware version will be displayed on the picture display for
about 20 seconds.
3. Check the firmware version displayed on the picture display.
• e.g. When the current version of the firmware is V1.00, the version will be shown as [MAIN
: V 1.00] as follows:
MAIN : V 1.00
BKUP : V X.XX
MONI : V X.XX
ADJD : V X.XX
EXTD : V X.XX
CPU1 : V X.XX
SH : XXXXXX
ST : XXXXXX
To Next Page
Need help?
General
