Firmware Update
M065/M066 5-10 SM
Menu > List/Test Print > Config. Page
Error Handling
An error code is shown if an error occurs during the download. Error codes have the letter
"E" and a number. If an error occurs, the firmware is not correctly downloaded; see the
error code table (
p.5-12 "Handling Firmware Update Errors") and do the necessary
steps. After this, download the firmware again.
Power Failure
If firmware update is interrupted by power failure, the firmware is not correctly downloaded.
In this condition, machine operation is not guaranteed. You have to download the firmware
again.
5.2.4 ADDRESS BOOK UPLOAD/DOWNLOAD
Download
1. Prepare a formatted SD card.
2. Make sure that the write-protection on the SD card is off.
3. Turn off the main power switch of the main machine.
4. Remove the SD slot cover from SD card slot 2 at the left rear side of the machine (
x
1).
5. Install the SD card into SD card slot 2 (for service use).
6. Turn on the main power switch.
7. Enter the SP mode.
8. Do SP5-846-051 (Backup All Addr Book).
9. Exit the SP mode, and then turn off the main power switch.
10. Remove the SD card from SD card slot 2.
11. Install the SD slot cover on SD card slot 2.
 If the capacity of SD card is not enough to store the local user information, an
error message is displayed.
 Carefully handle the SD card, which contains user information. Do not take it
back to your location.
To Next Page
Loading...
Need help?
General
