2. Make sure that an SD card is in SD Card Slot 1. The application program is copied to this SD card.
3.
Insert the SD card with the application program in SD Card Slot 2. The application program is
copied from this SD card.
4. Turn the main switch on.
5. Start the SP mode.
6. Select SP5-873-001 "Move Exec."
7. Follow the messages shown on the operation panel.
8. Turn the main switch off.
9. Remove the SD card from SD Card Slot 2.
10. Turn the main switch on.
11. Check that the application programs run normally.
Undo Exec
"Undo Exec" (SP5-873-002) lets you copy back application programs from an SD card to the original
SD card. You can use this program when, for example, you have mistakenly copied some programs by
using Move Exec (SP5-873-001).
• Do not turn ON the write protect switch of the system SD card or application SD card on the
machine. If the write protect switch is ON, a download error (e.g. Error Code 44) occurs during a
firmware upgrade or application merge.
1.
Turn the main switch off.
2. Insert the original SD card in SD Card Slot 2. The application program is copied back into this
card.
3. Insert the SD card with the application program in SD Card Slot 1. The application program is
copied back from this SD card.
4. Turn the main switch on.
5. Start the SP mode.
6. Select SP5-873-002 "Undo Exec."
7. Follow the messages shown on the operation panel.
8. Turn the main switch off.
9. Remove the SD card from SD Card Slot 2.
• This step assumes that the application programs in the SD card are used by the machine.
10.
Turn the main switch on.
SD Card Appli Move
183
To Next Page
Loading...
Need help?
General