• Do not hold down the main power switch while turning off the main power. Doing so forcibly turns
off the machine’s power and may damage the hard disk or memory and cause malfunctions.
• Do not press the main power switch soon after pressing the main power switch on the machine.
When you turn the power on or off, wait at least 10 seconds after confirming that the main power
indicator on the control panel has turned on or off.
1. Push the main power switch.
The main power is turned off automatically when the shutdown process is complete. If the shutdown
process is not complete within the period of time displayed on the screen, contact your service
representative.
Energy Saving Mode
When the machine is not operated for a specified period of time, the machine enters the "Energy Saver
Mode" automatically. "Energy Save mode" has two modes, "Low Power mode" and "Sleep mode". In
the factory default, the machine is configured to use "Sleep mode".
Low Power Mode
If the printer is not used for a certain period of time, it enters Low Power mode.
In Low Power mode, the printer consumes less electricity than in the standby mode by turning off the
display and lowering the temperature of the fusing unit heater. If the printer receives a job, it
increases the temperature of the fusing unit and perform printing, but the display remains off.
You can configure the period of time the printer waits before it enters Low Power mode in [Low
Power Mode Timer].
See "Maintenance", User Guide (Full Version).
To exit Low Power mode, do one of the following:
• Start print jobs
• Press any key on the control panel
• Load paper in the bypass tray
1. Getting Started
8
To Next Page
Loading...
Need help?
General
