Setting Items
Default
Value
Max.
Value
Min.
Value
Step Unit
01: 2 Holes JP/EU
02: 3 Holes US
03: 4 Holes EU
04: 4 Holes NE
05: 2 Holes US
0 4 -4 0.5 mm
0609: Set Number of Folds for Booklet
Specify the number of booklet folds to be performed when using Booklet Finisher.
You can adjust the paper folding strength by changing the number of folds per the booklet.
When you select "0", the default value, the finisher folds the booklet according to the number of sheets
in the booklet, as shown below.
• 1–6 sheets: 1 time
• 7–10 sheets: 2 times
• 11–30 sheets: 6 times
The value set here is added to the default values. Set a negative value to reduce the number of times the
finisher folds booklets.
Setting Items
Default
Value
Max.
Value
Min.
Value
Step Unit
01: Number of Folds for Booklet 0 6 -6 1 None
0637: Staple Tray: Rib Installed Mode to Strengthen Paper
Set the operation when the Paper Strengthening Rib is installed to Staple Tray.
This function can be used with Finisher or Booklet Finisher.
Before you set "Setting" to [On], attach the paper strengthening ribs.
Setting Item Values Default Value
01: Setting Off
On
Off
5. Adjustment Settings for Operators
206
To Next Page
Loading...
Need help?
General
